Bedienungsanleitung Candy FPP 698 X (Seite 12 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

466071

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

11 GB

SELF-CLEANING OVEN WITH CATALYTIC

Special self-cleaning panels covered in a micro-porous coating

are available as optional extras for all models. If they are fitted,

the oven no longer needs to be cleaned by hand.

The fat that is splattered onto the sides of the oven during roasting

is eliminated by the microporous coating which breaks the fat

down by catalysis and transforms it into gas.

Excessive splattering may nevertheless block the pores and

therefore hinder self-cleaning. The self-cleaning capacity may be

restored by switching on the empty oven to maximum for about

10-20 minutes.

Do not use abrasive products, metal cleaning wads, sharp objects,

rough cloths, or chemical products and detergents that may

permanently damage the catalytic lining.

It is a good idea to use deep roasting trays to roast fatty foods

such as joints of meat etc. and to put a tray underneath the grill

to catch surplus fat.

If the walls of the oven are so thickly coated in grease that the

catalytic lining is no longer effective remove surplus grease with

a soft cloth or sponge soaked in hot water.

The lining must be porous for self-cleaning to be effective.

N.B.: All catalytic linings currently on the market have a working

life of about 300 hours. They should therefore be replaced after

about 300 hours.

SERVICE CENTRE

Before calling the Service Centre

If the oven is not working, we recommend that:

• you check that the oven is properly plugged into the power

supply.

If the cause of the fault cannot be detected:

disconnect the oven from the mains, do not touch the oven and

call the after sales service.

Before calling the Service Centre remember to make a note

of the serial number on the specifications plate.

The oven is supplied with a guarantee certificate that ensures that

it will be repaired free of charge by the Service Centre whilst

under guarantee.

This appliance is marked according to the

European directive 2002/96/EC on Waste

Electrical and Electronic Equipment (WEEE).

By ensuring this product is disposed of correctly,

you will help prevent potential negative

consequences for the environment and human

health, which could otherwise be caused by

inappropriate waste handling of this product.

The symbol on the product indicates that this

product may not be treated as household waste.

Instead it shall be handed over to the applicable collection point

for the recycling of electrical and electronic equipment

Disposal must be carried out in accordance with local

environmental regulations for waste disposal.

For more detailed information about treatment, recovery and

recycling of this product, please contact your local city office,

your household waste disposal service or the shop where you

purchased the product.

IMPORTANT:

Before carrying out pyrolysis:

• Take all accessories out of the oven as they will be damaged

in the high pyrolysis temperatures;

• Clean away all excess food spills or large scraps of food

which would take too long to be destroyed. Effectively, large

amounts of grease may catch fire under the intense heat

emitted by pyrolysis.

• Close the oven door.

• If you have an hob top installed above the oven, never use

the gas burners or the electric plates during pyrolysis to avoid

excessive heating of the oven’s control panel.

It is strongly advised not to use detergents or any other

recommended product for cleaning ovens.

Open the oven door.

Pyrolysis leaves a white residue on the oven walls. Wait for the

oven to cool completely then clean the inside of the oven with

a damp sponge to wipe off the residue.

Remarks:

• you will save energy by cleaning directly after cooking

thus making use of the residual heat in the oven.

CLEANING THE OVEN : PYROLYSIS

- according to the model -

Pyrolysis is a cleaning method that uses high temperatures to

destroy dirt.

The resulting smoke is cleaned by the passage of a catalyser.The

oven door is provided with a safety lock that prevents it being

opened during pyrolysis due to the necessity of high temperatures.

The pyrolysis cycle may result in a slight odour in the kitchen

which will be more or less noticeable depending on the latter’s

aeration.

The pyrolysis oven is fitted with a cooling fan which protects the

control panel and electronics from heat damage. It begins when

the pyrolysis cycle reaches high temperatures and continues to

rotate after the oven has been switch off until the centre oven

temperature is high.

1. Rotate the function selector to the position P.

On the display, appears the indication « ECO » or « SUP »

2. The preset time is 1.30 hrs, this can be varied from 1.30 hrs

(Eco mode) to 2 hrs (Sup mode) via the programmer (buttons

« + » or « - »). If the oven is very dirty, it is recommend o increase

the time to 2 hrs, if the oven is moderately dirty reduce the cleaning

cycle time to 1.30 hr.

3. It is possible to defer the start time of the pyroclean cycle by

changing the END time via the programmer.

4. After few minutes, when the oven reaches a high temperature,

the door locks automatically.

5. The pyroclean cycle can be stopped at any time by turning the

function selector back to ‘0’ (the word OFF will be displayed for

3 seconds)

6. Once the pyroclean cycle is finished, the pyrolysis will switch

off automatically. On the display appears the indication « END »

until the door is locked then « 0- - n »

7.You can turn the function selector back to « 0 » but if the

temperaure is still high, the 0- - n indication appears to inform

that the door is locked.

Candy FPP 698 X Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info