Bedienungsanleitung Cannondale IQ400 - 2012 (Seite 1 von 6) (Englisch)

637189

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

THANK YOU FOR PURCHASING A CANNONDALE

Congratulations on your purchase of a Cannondale IQ Series computer.

Proper setup and operation will greatly enhance this product’s usefulness and your

enjoyment.

Please follow all Warnings and read all sections of this manual carefully and become fully

familiar with its operation before using it.

YOUR CANNONDALE RETAILER

Along with this manual, your key source of information and assistance is the shop where

you purchased this product. Your local Authorized Cannondale Retailer is your primary

contact to discuss service and adjustment to this product, instruction in its use, and any

warranty questions.

To nd an Authorized Cannondale Retailer closest to you, call 1800BIKEUSA. Or you can

use our dealer locator at our website www.cannondale.com.

IMPORTANT INFORMATION FOR ALL CANNONDALE CYCLING COMPUTERS

WARNINGS

WIRELESS COMPUTER MODELS (IQ200, IQ300, and IQ400) - People with medical/

implanted electronic equipment or devices such as heart pacemakers, EKG equipment,

etc. must not use wireless cycle computers due to possible risk of interference with the

medical devices.

EXERCISE - Adults with health problems (such as heart disease, diabetes or obesity) or

those at high risk, men over age 40 and women over age 50 or pregnant should talk

with their doctor before starting an exercise program.

INTENDED USE: For bicycle use only. Not for use on any motorized vehicle.

OPERATE COMPUTER ONLY WHEN NOT RIDING: Failure to pay attention to the road,

trail, trac or your surroundings could result in an accident, with risk of serious injury,

paralysis or death. You must focus on riding, not your computer. Learn computer opera-

tions, and do all possible computer operations when not riding. For any operations you

choose to perform while riding, choose a time and place where this distraction has less

risk.

MAKE SURE ALL COMPUTER PARTS ARE INSTALLED PROPERLY: The computer

must not interfere with the bicycle controls and your ability to use them. Mount the

computer according to the directions in this instruction manual. See your Authorized

Cannondale Retailer if you have any trouble installing or maintaining your computer.

CHECK FOR DAMAGE REGULARLY: Regularly check the position, alignment, and

condition of the spoke magnet, wireless sensor, cadence sensor, sensor and sensor wire

to make sure they are secure, aligned and in good condition. Make sure nothing is loose

and there are no worn or damaged parts.

BATTERIES: Use only battery size and type specied on the unit. Do not leave any

batteries in reach of children, and dispose of them correctly. If a battery is swallowed,

consult a doctor immediately.

NOT A TOY: Keep this computer and associated parts including the battery away from

children. Small parts could be swallowed.

YOU CAN BE SEVERELY INJURED, PARALYZED OR KILLED IN AN ACCIDENT IF YOU

IGNORE THESE WARNINGS.

NOTICE

■ This product is rain-proof only. Do not submerge or power wash.

■ Do not disassemble the unit.

■ Mount the computer according to the directions in this instruction manual.

■ Avoid direct impact to the computer unit.

■ Avoid using the computer unit in or near strong electromagnetic elds such as

high-voltage power lines or other transmitters.

■ Clean the unit with a mild detergent and a soft dry cloth. Never use any kind of

solvent or alcohol.

■ To prevent damage caused by battery leakage, remove the batteries before storage

or long period of non-use. Do not reverse battery installation. Observe positive (+)

and negative (-) markings.

■ WIRELESS MODELS (IQ200,IQ300, IQ400) Wireless computer uses an analog

wireless signal. It is not digitally coded but uses technology to lower the chance of

interference with circuitry used in other electronic devices such as lights, phones ,

computers, etc.

2012 IQ400 Computer

Setup and Owners Manual - 11/11

COMPUTER PARTS

COMPUTER INSTALLATION

The computer unit can be mounted on a bicycle handlebar or stem.

1. To mount the bracket, insert two nylon ties through the mounting bracket slots.

(a) - handlebar slots, (b) stem slots

2. Insert the rubber pad into back of mount bracket for handlebar or stem by aligning

slots in the back of the mount with the pad.

3. Position the pad/bracket onto the handlebar or stem and tighten both nylon ties

securely. Carefully snip tie ends 1-2mm from tie head.

To mount the computer onto the bracket, position it into the bracket at a 45 degree angle,

hold down and rotate the computer unit clockwise to lock it in place. To remove it, rotate

the computer counter-clockwise and lift it o.

NYLON TIES

MOUNTING BRACKET

HANDLEBAR

Check the following components before installation:

IQ400 COMPUTER UNIT

MOUNTING BRACKET

WIRELESS SPEED

& CADENCE SENSOR

CADENCE MAGNET

(back)(front)

(front)

NYLON TIES (X5)

SPOKE MAGNET

SENSOR

STABILIZING PADS (X2)

MOUNTING PAD

(back)

SENSOR INSTALLATION

MAX.

150 cm

SPOKE

MAGNET

CADENCE

SENSOR PIN

GREEN LED LIGHT

SPEED

SENSOR

ARM

STABALIZING

PAD

SPOKE

MAGNET

1~5mm

CADENCE

MAGNET

ADJUSTABLE

CADENCE MAGNET

1. Loosen (DO NOT REMOVE) the screw on the adjustable Speed Sensor arm. Position

the sensor on the top of the non-drive chainstay within 150 mm of the computer. The

Cadence Sensor pin and battery door must point out toward the crank arm as shown.

Cannondale IQ400 - 2012 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info