779950
12
Zoom out
Zoom in
Vorherige Seite
1/15
Nächste Seite
11
KP018/ - ceramic
KB6180/ - standard
39mm 34mm
BB30-73A
Asymmetric
73mm
(5mm)
Non-Drive Side Drive Side
34mm
BB30 - 68mm
34mm
BOTTOM BRACKET
The bottom bracket shell width is BB30-73A cranksets. See www.BB30standard.com.
SISL2 Crankset Installation
The following procedure should only be completed
by a professional bike mechanic.
For Loctite instructions: http://tds.loctite.com
1. Connect the SISL2 drive side crankarm to the spiderring.
Apply Loctite 242 to the crankarm spidering interface and
lockring. Tighten the lockring to 47Nm (34 FtLbs) using the
Cannondale special tool KT012/.
2. Apply grease to the drive side end of the 109mm SISL2
spindle and the crankarm spline hole. Also apply grease to
the fixing bolt threads and thin washer. Tighten the fixing
bolt with a 10mm Allen key to 40 Nm, (30 FtLbs).
3. Slide the 2.5mm drive side spacer marked “BB30 SISL2 DRIVE
SIDE SPACER” onto spindle followed by the SL2 bearing shield.
The markings on the shield face out.
4. Apply bearing grease to the spindle and slide drive side crank
arm/spindle into the non-drive side BB bearing. Use a rubber
mallet to tap the crankarm through until the spacer and shield
are seated against the drive side BB bearing.
5. On the non-drive side, slide the bearing shield onto the
spindle end. The markings on the shield face out.
6. Slide the wave washer and one 0.5mm shim onto the spindle.
7. Slide the non-drive side spacer onto the spindle, marking
facing out.
8. Apply bearing grease to the crankarm BB spline hole, spindle
end and the thin washer and fixing bolt threads. Tighten-non
drive the fixing bolt to 40 Nm, (30 FtLbs) and check to see
if wave washer is properly preloaded (still has slight wave
and not loose). If it is loose, remove the crankarm and add
another shim. Up to 3 shims can be used. Add shims as
needed.
9. When the preload is set and the non-drive side fixing bolt is
torqued, you are done.
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Cannondale Slice Multisport wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Cannondale Slice Multisport

Cannondale Slice Multisport Zusatzinformation - Deutsch - 15 seiten

Cannondale Slice Multisport Zusatzinformation - Holländisch - 15 seiten

Cannondale Slice Multisport Zusatzinformation - Französisch - 15 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info