Bedienungsanleitung Canon EOS 1D Mark III (Seite 28 von 212) (Englisch)

46688

Zoom out

Zoom in

Vorherige Seite

1/212

Nächste Seite

Recharging the Battery

The <CAL/CHARGE> lamp blinks in red.

This indicates that you should calibrate the battery so that the correct battery level is detected

and the camera’s battery level indicator can display the correct battery level. Calibration is not a

required operation. If you want to just recharge the battery, you can let the battery start

recharging automatically after about 10 sec. If you want to do the calibration, press the

CALIBRATE

> button while the <

CAL/CHARGE

> lamp is blinking in red. The Charge

level indicator will blink in red and the calibration (power discharge) will start.

After the calibration is completed, the battery will start recharging automatically. Note that

the less depleted the battery, the longer the calibration will take. The <

>, <

>, and

10h

> figures on the side of the Charge level indicator respectively indicate the

approximate number of hours it will take to complete the calibration (power discharge). If

the <

10h

> indicator blinks in red, it will take approx. 10 hours. After the calibration is

completed and the battery is totally drained, it will take a further 2 hours to recharge the

battery fully. If you want to stop the calibration before it is completed and start recharging

the battery, remove the battery from the charger and attach it to the charger again.

All three Charge level indicators blink.

If all three Charge level indicators blink in green, it means that the battery’s internal temperature

is not within 0°C - 40°C / 32°F - 104°F. The battery will start recharging when the internal

temperature is within 0°C - 40°C / 32°F - 104°F.

If all the Calibration (discharge) status indicators blink in red or if all the lamps blink between

green and red (including the <

CAL/CHARGE

> lamp), remove the battery from the charger

and take it to your dealer or to nearest Canon Service Center.

Also, if a battery other than the LP-E4 is attached to the charger, the lamps will blink between

red and green (including the <

CAL/CHARGE

> lamp) and the battery cannot be recharged.

Use the car’s cigarette lighter socket to recharge the battery.

With Car Battery Cable CB-570 (optional), you can connect the charger’s car

battery cable socket (<

DC IN

> terminal) to your car’s cigarette lighter socket.

• When recharging the battery this way, be sure that the car’s engine is on.

If the car engine is off, disconnect the car battery cable from the cigarette

lighter socket. If you leave the car battery cable connected to the

cigarette lighter socket, it may drain the car battery.

• Do not use a transformer with the battery charger.

• Battery charging from a car battery is possible only with a 12 V DC or

24 V DC car battery in a minus-grounded car. The shape or dimensions

of the cigarette lighter socket in certain cars might not be compatible with

the car battery cable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon EOS 1D Mark III Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Canon EOS 1D Mark III

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info