Bedienungsanleitung Canon LV-7297S (Seite 22 von 77) (Englisch)

543075

Zoom out

Zoom in

Vorherige Seite

1/77

Nächste Seite





PIN (Personal Identification Number) code is a

security code that allows the person who knows

it to operate the projector. Setting a PIN code

prevents unauthorized use of the projector.

A PIN code consists of a four-digit number. Refer

to the PIN code lock function in the Setting Menu

on pages 55-56 for locking operation of the

projector with your PIN code.



Use the Point ▲▼ buttons to enter a number.

Press the Point ► button to fix the number and

move the red frame pointer to the next box. The

number changes to . If you fixed an incorrect

number, use the Point ◄ button to move the

pointer to the number you want to correct, and

then enter the correct number.

Repeat this step to complete entering a four-digit

number.

After entering the four-digit number, move the

pointer to “Set”. Press the OK button so that you

can start to operate the projector.

If you entered an incorrect PIN code,  

and the number () will turn red for

a moment. Enter the correct PIN code all over

again.



If you forget your PIN code, the projector can no

longer be started. Take special care in setting

a new PIN code. Write down the number as a

reminder. Should the PIN code be missing or

forgotten, consult your dealer or service center.

After the OK icon disappears,

you can operate the projector.





•If the PIN code number is not entered or wrong PIN

code number is entered within three minutes after the

PIN code dialog box appeared, the projector will be

turned off automatically.

•The “1234” is set as the initial PIN code at the factory.



Remaining Time until the lamp is off.



This projector has the Power Management mode

function. When there is no signal input for more

than 30 seconds and also there is no operation to

the projector, the   image appears and

the countdown begins. After the countdown, the

lamp will be off. This function helps to save power

consumption and extend the lamp life. (p. 51)





The cooling starts when the countdown is finished and the lamp is off. During the cooling, the POWER

indicator blinks red, and do not do any operation to the projector.

The POWER indicator blinks green when the cooling is completed and it goes to the Power Management

mode. In this condition, the projection lamp will be turned on and image will be projected if the input signal

is reconnected or any button on the top control or remote control unit is pressed.

The cooling starts when the countdown is finished and the lamp indicator is off. During the cooling, the

POWER indicator blinks red, and do not do any operation to the projector.

The power will be turned off and the projector goes to Standby mode when the cooling is completed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon LV-7297S Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info