Bedienungsanleitung Canon lv 7365 (Seite 5 von 83) (Englisch)

214800

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

Important Information

10˚

For UK only: In UK, a BS approved power cord with moulded plug has a Black (ve Amps) fuse installed for use

with this equipment. If a power cord is not supplied with this equipment please contact your supplier.

Important Safeguards

These safety instructions are to ensure the long life of your projector and to prevent re and shock. Please read

them carefully and heed all warnings.

Installation

• Do not place the projector in the following conditions:

- on an unstable cart, stand, or table.

- near water, baths or damp rooms.

- in direct sunlight, near heaters or heat radiating appliances.

- in a dusty, smoky or steamy environment.

- on a sheet of paper or cloth, rugs or carpets.

• If you wish to have the projector installed on the ceiling:

- Do not attempt to install the projector yourself.

- The projector must be installed by qualied technicians in order to ensure proper operation and reduce

the risk of bodily injury.

- In addition, the ceiling must be strong enough to support the projector and the installation must be in ac-

cordance with any local building codes.

- Please consult your dealer for more information.

Do Not Use in the Following Environments

Do not install the projector in a humid or dusty place or a place where there is much oily

smoke or cigarette smoke. Optical parts such as a lens and mirror are stained, resulting in

poor picture.

Do not use the projector in a place where the temperature becomes very high or low.

Operating temperature: +5°C to +40°C Storage temperature: -10°C to +50°C

(Quiet mode selected automatically at 95°F to 104°F / 35°C to 40°C)

Place the projector in a horizontal position

The tilt angle of the projector should not exceed 10 degrees, nor should the projector be installed in any way other

than the desktop and ceiling mount, otherwise lamp life could decrease dramatically.

Fire and Shock Precautions

• Ensure that there is sufcient ventilation and that vents are unobstructed to prevent the build-up of heat in-

side projector. Allow at least 1 m (3.3') of space between your projector and a wall.

• Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated

the projector is turned on and immediately after the projector is turned off.

• Prevent foreign objects such as paper clips and bits of paper from falling into your projector. Do not attempt

retrieve any objects that might fall into your projector. Do not insert any metal objects such as a wire or

screwdriver into your projector. If something should fall into your projector, disconnect it immediately and

have the object removed by a qualied service personnel.

• Do not place any objects on top of the projector.

• Do not touch the power plug during a thunderstorm. Doing so can cause electrical shock or re.

• The projector is designed to operate on power source voltages indicated on indicated in the rating label on

the projector. Ensure that your power ts this requirement before attempting to use your projector.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon lv 7365 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info