Bedienungsanleitung Canon LX-MU500 (Seite 12 von 85) (Englisch)

709681

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

Precautions for the remote control battery

• Be sure to remove the power plug from the power outlet before replacing the lamp.

• When the lamp is damaged, shards of glass may be scattered inside the projector. Contact the Canon

Customer Support Center for cleaning and inspection of the projector interior and lamp

replacement.

When handling the lamp, pay attention to the following points.

•Be sure not to handle the lamp immediately after it has been used. Be sure to switch off the

power and wait for approximately 45 minutes for the lamp and the projector to cool down

sufficiently. Failure to do so could result in a burn or personal injury due to heat from the

lamp or projector.

• When an instruction to replace the lamp has been displayed (LAMP Indicator Displays (See

"Timing of replacing the lamp" on page 67 for details)), the possibility of the lamp breaking will

increase. Replace the lamp with a new one as soon as possible.

• If the lamp is damaged, gas inside the lamp (containing mercury) and dust may be emitted from the

exhaust vents. If this happens, immediately open the windows and doors to provide ventilation to

the room. If you inhale any gas emitted from the lamp or it has come into contact with your eyes or

mouth, consult a doctor immediately.

• When disposing of a used mercury lamp, dispose of it in the same way as a fluorescent lamp and in

accordance with the local regulations where you live.

Warning

Caution

Pay attention to the following points regarding handling of the battery. Failure to do so could result in a

fire or injury.

• Do not place the battery in a fire or apply heat to, short circuit or disassemble the battery.

• Do not attempt to recharge the battery.

• Insert the battery in the correct + / – positions.

• If any liquid leaks from the battery and comes into contact with skin, wash off thoroughly with

water.

Warning

Installation and Handling Precautions

• Do not install the projector in a location that is damp, or where there is a lot of dust, oily smoke or

tobacco smoke. Doing so could cause contamination of optical components such as the lens and the

mirror and may result in deterioration of image quality. In addition, oil can degrade the plastic,

which could result in a ceiling-mounted projector falling from its mounting.

• Do not use adhesives, lubricants, oils, or alkaline detergents for maintenance of the projector. They

could adhere to the plastic and deteriorate it, possibly resulting in the projector falling if it is ceiling-

mounted.

• Make sure to implement anti-fall measures such as an anti-fa l wire when installing the projector in

high places, for example, installing it on the ceiling.

• Do not use a lens cleaning paper or lens cleaner.

• Before cleaning the lens, always turn the projector off and cool it down.

Warning

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon LX-MU500 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Canon LX-MU500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info