Bedienungsanleitung Canon LX-MW500 (Seite 64 von 85) (Englisch)

709680

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

Maintenance

Care of the projector

Your projector needs maintenance from time to time, depending on the environmental circumstances, and

should be done by authorized service technicians only. Contact your dealer for instructions.

What you can do yourselves on a regular basis is to keep the lens clean, keep the cabinet clean, and

replace the air filter.

Never remove any parts of the projector except the lamp and air filter cover. Contact your dealer if other

parts need replacing.

Have the interior of the projector cleaned at regular intervals.

If the projector is used for a long period of time, dust could accumulate inside the projector. This could

cause a fire or malfunction. It is recommended that periodic maintenance of the projector be performed.

For details of maintenance costs, contact the Canon Customer Support Center.

Cleaning the lens

Clean the lens whenever you notice dirt or dust on the surface.

• Use a canister of compressed air to remove dust.

• If there is dirt or smears, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently

wipe the lens surface.

• Never rub the lens with abrasive materials.

Cleaning the projector case

Before you clean the case, turn the projector off using the proper shutdown procedure as described in

"Shutting down the projector" on page 47 and unplug the power cord.

• To remove dirt or dust, wipe the case with a soft, lint-free cloth.

• To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral pH detergent. Then

wipe the case.

• Never use wax, alcohol, benzene, thinner or other chemical detergents. These can damage the case.

• Flammable substances may ignite causing fire or breakdown while the lamp is illuminating.

Replacing the air filter

Be sure to use the air filter dedicated to this projector, LX-FL02. The air filter is not bundled with the

package of the projector. Contact your dealer for purchase of the air filter.

Before you replace the air filter, turn the projector off using the proper shutdown procedure as described

in "Shutting down the projector" on page 47 and unplug the power cord.

Follow the below illustrations to replace the air filter (LX-FL02). Contact your dealer when replacing the

air filter unit with the projector mounted to the ceiling.

Setting Filter Mode as On

Set Filter Mode to On only when using the projector after the air filer is properly attached. Failing to do

so will result in a shorter lamp life.

1. Press MENU and then press / until the SYSTEM SETUP: Advanced menu is highlighted.

2. Press to highlight Filter Settings and press OK/IMAGE. The Filter Settings page is displayed.

3. Press to highlight Filter Mode and press / to select On.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon LX-MW500 Seite 64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Canon LX-MW500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info