Bedienungsanleitung Canon PIXMA MG8140 (Seite 1102 von 1135) (Englisch)

596295

1102

Zoom out

Zoom in

Vorherige Seite

1/1135

Nächste Seite

Advanced Guide

About Network Communication

Troubleshooting

> Cannot Communicate With the Machine/Cannot

Print from the Machine

N042

Cannot Communicate With the Machine/Cannot Print from the

Machine

Cannot Communicate with the Machine After Applying MAC/IP Address Filtering or Entering a WEP/

WPA/WPA2 Key to the Access Point

Cannot Communicate with the Machine After the Network Settings Are Changed

Cannot Connect to the Target Access Point

When Encryption Is Enabled, Cannot Communicate With the Machine After the Encryption Type Was

Switched on the Access Point

Cannot Communicate with the Machine with USB Connection

Cannot Communicate with the Machine over the Wireless LAN

Cannot Communicate with the Machine over the Wired LAN

The Machine Cannot Be Detected in the Wireless LAN

The Machine Cannot Be Detected in the Wired LAN

Cannot Communicate with the Machine After Applying MAC/IP Address Filtering or

Entering a WEP/WPA/WPA2 Key to the Access Point

Check 1: Confirm the access point setting.

Refer to the manual provided with the access point or contact its manufacturer to confirm the

access point setting. Make sure that the computer and the access point can communicate

with each other under this setting.

Check 2: If you are performing MAC address filtering or IP address filtering at the

access point, confirm that the MAC address or IP address for both the computer

or the network device and the printer are registered.

Check 3: If you are using a WEP/WPA/WPA2 key, make sure that the key for the

computer or the network device and the printer matches that set to the access

point.

Besides the WEP key itself, the key length, key format, the key ID to use, and the

authentication method must match among the machine, the access point, and the computer.

Normally, select Auto for the authentication method. If you want to specify the method

manually, select Open System or Shared Key according to the setting of the access point.

How to Set a WEP/WPA/WPA2 Key

Cannot Communicate with the Machine After the Network Settings Are Changed

Wait until the IP address is assigned to the computer. You may need to restart your computer.

Search for the printer again after confirming a valid IP address is assigned to the computer.

Cannot Connect to the Target Access Point

Check 1: Make sure that the SSID/network name of the target access point and

the machine are identical.

For the procedures to connect an access point and set it up, refer to the manual of your

access point or contact its manufacturer.

For the procedures to set up the printer, see Changing the Settings in the Wireless LAN

Sheet

Page 1102 of 1135 pagesCannot Communicate With the Machine/Cannot Print from the Machine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon PIXMA MG8140 Seite 1102

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Canon PIXMA MG8140

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info