Bedienungsanleitung Canon PowerShot SX430 IS (Seite 31 von 146) (Englisch)

733850

Zoom out

Zoom in

Vorherige Seite

1/146

Nächste Seite

Before Use

Basic Guide

Advanced Guide

Camera Basics

Auto Mode

Other Shooting Modes

Playback Mode

Wi-Fi Functions

Setting Menu

Accessories

P Mode

Appendix

Index

● You can change how long images are displayed after shots

(

40).

Movies

● Beforeshootingamovie,lowertheashwithyournger.

Be careful not to touch the microphone (1) when shooting a

movie.Leavingtheashraised,orblockingthemicrophonemay

prevent audio from being recorded or may cause the recording to

soundmued.

● Avoid touching camera controls other than the movie button when

recording movies, because sounds made by the camera will be

recorded.

● Once movie recording begins, the image display area changes

andsubjectsareenlargedtoallowforcorrectionofsignicant

camera shake. To shoot subjects at the same size shown before

shooting, adjust the image stabilization setting (

59).

(

)

● Audio recording is monaural.

● When you recompose shots, the

focus, brightness, and colors will be

automatically adjusted.

3) Finish recording.

● Press the movie button again to stop

recording. The camera beeps twice as

recording stops.

● Recording will stop automatically when

the memory card becomes full.

Still Images/Movies

● If the camera makes no operating sounds, it may have been

turned on while holding down the [

] button. To activate

sounds, press the [

] button, choose [Mute] on the [ ]

tab, and then press the [

][ ]buttonstochoose[O].

Still Images

● A blinking [ ] icon warns that images are more likely to be

blurred by camera shake. In this case, mount the camera on a

tripod or take other measures to keep it still.

● Ifyourshotsaredarkdespitetheashring,moveclosertothe

subject.Fordetailsontheashrange,see“Flash”(

138).

● The subject may be too close if the camera only beeps once

when you press the shutter button halfway. For details on the

range of focus (shooting range), see “Shooting Range (measured

from the tip of the lens)” (

138).

● To reduce red-eye and to assist in focusing, the lamp may be lit

when shooting in low-light conditions.

● A blinking [

] icon displayed when you attempt to shoot

indicatesthatshootingisnotpossibleuntiltheashhasnished

recharging.Shootingcanresumeassoonastheashisready,

so either press the shutter button all the way down and wait, or

release it and press it again.

● Although you can shoot again before the shooting screen

is displayed, your previous shot may determine the focus,

brightness, and colors used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon PowerShot SX430 IS Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Canon PowerShot SX430 IS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info