Bedienungsanleitung Canon WUX6500 (Seite 19 von 210) (Englisch)

709661

Zoom out

Zoom in

Vorherige Seite

1/210

Nächste Seite

Safety Instructions

Pay attention to the following points regarding installation and handling of the projector.

Failure to do so may cause a fire, electric shock or personal injury.

• Do not remove the cabinet from the projector or disassemble it. The interior

of the projector contains high-voltage components as well as parts that are

hot. If inspection, maintenance or repair is required, contact the Canon

Customer Support Center.

• Do not disassemble or modify the projector (including consumable parts) or

the remote control.

• Do not look directly into the exhaust vents during use.

• Do not insert any object into vents in the projector, such as the air intake vent

or exhaust vents.

• Do not place a pressurized can in front of the exhaust vents. The pressure of

the contents of the can may increase due to heat from the exhaust vents and

this could result in an explosion.

• When cleaning off dust or dirt from projector parts such as the lens or filter,

never use any spray that is flammable. Internal parts that become hot may

ignite and cause a fire.

• Light from the projector is classified as

Risk Group 3 (RG3) according to

IEC 62471:2006.

• Possibly hazardous optical radiation emitted

from this product. Do not look at operating lamp. Eye injury may result. Pay

particular attention to prevent small children from doing so.

• When setting the projector on a high surface for projection, be sure the

surface is flat and stable.

• Do not use the projector on a soft surface such as carpet or sponge mat, etc.

Doing so could cause heat to build up inside the projector and this could

result in a fire.

• For ceiling mounting precautions, refer to the installation manual included

with the ceiling mount (sold separately).

• When hanging the projector from a ceiling, put the projector down on the

floor or a workbench before attaching or replacing the lens unit. Failure to do

so could result in parts falling off the projector and may cause an accident or

personal injury.

Precautions on the Lamp

This projector uses a high-pressure mercury lamp, which must be handled carefully and

correctly as described below.

The mercury lamp has the following characteristics.

• The lamp will gradually become darker over time.

• Impact, abrasion, or use of worn-out lamps may cause lamps to rupture (accompanied

by a loud noise) or burn out.

• Lamps are more likely to rupture after the lamp replacement message is displayed (see

“Replacing the Lamp” (P173)). Replace the lamp with a new one as soon as possible.

• Useful life of lamps varies widely from lamp to lamp and depending on the environment

of use. Some lamps may fail or rupture soon after they are first used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Canon WUX6500 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Canon WUX6500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info