215651
145
Zoom out
Zoom in
Vorherige Seite
1/168
Nächste Seite
145
Maintenance
Appendix
Replacing the Lamp
When the time of use of the lamp exceeds the certain amount of time, the following mes-
sage (two types) is displayed for 10 seconds every time the projector is turned on.
1,800 - less than 2,000 hours
After this screen has been displayed for 10 seconds and disappeared, all buttons
become operable.
This message will not be displayed again if you select [Cancel] in response to the mes-
sage "Do you want to display this message again?".
Over 2,000 hours
After this screen has been displayed for 10 seconds and disappeared, all buttons
become operable.
You can check the time of use of the lamp in [Lamp counter] in the [System settings]
menu (P109).
About the Replacing Lamp
This projector uses the following lamp.
Lamp type No.RS-LP05
Be sure to use the specified lamp.
A lamp can be ordered from your dealer.
When replacing the lamp, turn off the projector, wait until the cooling fan stops, disconnect the
power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you
may get burned because the main unit is very hot immediately after the projector is turned off.
Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector 's
performance may degrade.
Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or
shocked. If a lamp explodes, follow the instructions under "If a Lamp Explodes" on page 18.
Do not remove screws unless specified.
Prepare the new lamp when this screen is dis-
played.
Only [<], [>], the OK button, and the POWER
button are available while this screen is dis-
played.
When you press the POWER button, "Push
POWER button again to turn off power." mes-
sage appears.
Replace the lamp by referring to the procedure
on page 146 when this screen is displayed.
Only the POWER button is available while this
screen is displayed.
When you press the POWER button, "Push
POWER button again to turn off the power."
message appears.
Caution
145

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Canon xeed sx800 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Canon xeed sx800

Canon xeed sx800 Bedienungsanleitung - Deutsch - 154 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info