Editing
96
E
(ii) Choosing the output channel
1. Make sure the camera is set to VCR mode.
2. Open the VCR menu and select VCR SET UP.
3. Select OUTPUT CH, then select the output channel.
4. Close the menu.
Notes:
• When you have chosen the output, “STEREO1”,
“STEREO2”, or “MIX” is shown in the top left of the
viewfinder and in the audio LCD panel. If you turn
the power off, the output (and display) is set to
“STEREO1”.
• You cannot mix the balance without first releasing the
fixed level: the camera will show “FIXED” in the
viewfinder.
L/R (the default setting):
• If the audio mode is 16 bit or 12 bit stereo 1, the audio signal will be sent to the RCA jacks labelled
L and R.
• If you chose stereo 1 for the output at stage (i), stereo 1 (L & R) will be sent to the RCA jacks labelled
Audio 1 (L & R). In addition, stereo 2 (L & R) will be sent to the RCA jacks labeled Audio 2 (L & R).
This gives you four independent audio signals.
• If you chose stereo 2 for the output at stage (i), stereo 2 (L & R) will be sent to Audio 1 (L & R).
• If you mixed the balance at stage (i), the combination of left channels from stereo 1 and stereo 2 will be
sent to the left channel of Audio 1 and the combination of the right channels will be sent to the right
channel of Audio 1.
L/L
• Only sound from the left channel(s) is output. This output is sent to the RCA jacks (L & R).
R/R
• Only sound from the right channel(s) is output. This output is sent to the RCA jacks (L & R).
L+R/R
• Gives a mono output. Sound from the left and right channels are combined and sent to the left RCA
jack(s).
Note:
• The audio sent to connected headphones is the same as sent to the Audio 1 RCA jacks.
(see p. 26)
