Bedienungsanleitung Cardiowise XRCISE Care (Seite 13 von 56) (Englisch)

737736

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

XRICSE CARE - Description

3.5.4 Individual or group training

A patient can either be entered in a slot for individual training or train within a group.

Group training makes sense if the same group of patients always shows up for a training

session. These patients are put into a group in the XRCISE CARE software. At the start of

training, the patients in the group can be assigned to the slots with a few simple mouse clicks.

This saves time. The training itself can either be started for all patients at the same time, or

individually per patient. As in the individual training, each patient in the group can go through

their individual training.

3.5.5 Training on equipment

Training on an ergometer or treadmill is categorically divided into 5-phase training. It is

divided into:

⊗ AP1 : Warm-up phase 1

⊗ AP2 : Warm-up phase 2

⊗ TP : Training phase

⊗ EP1 : Recovery phase 1

⊗ EP2 : Recovery phase 2

A constant load is applied in the phases AP1 and EP2, while the load is slowly increased or

decreased in the phases AP2 and EP1. The load can also vary during the actual training

phase.

The therapist enters the training parameter settings and adjusts them individually to each

patient.

3.5.6 Pulse, load, and interval training as well as Intelli mode

A 5-phase training on equipment is performed under either load or pulse control.

A pulse-controlled training can only be performed with an ergometer training, not with a

treadmill training. During a pulse controlled training, the heart rate signal of the applied ECG

sensor is included in the ergometer load control. The therapist specifies a patient-dependent

target heart rate. The XRCISE CARE software compares the current value from the ECG

sensor with the specified target value and modifies the ergometer control signal

correspondingly. This causes the ergometer to adjust the load to the patient.

During load controlled training, the therapist specifies the patient-dependent maximum load

for the exercise equipment. During the 5-phase training, the exercise equipment increases

the load up to the specified target value according to the specified training profile.

Interval training is always load controlled and can only be selected for ergometer training.

During interval training, very short load phases alternate with short recovery phases. The

advantage of interval training is the low stress on the cardiovascular system with simultaneous

training of the musculature.

If the Intelli mode is activated during load controlled training, the load in the AP1 and EP2

phases is at a specific ratio relative to the load during the training phase. This ratio is defined

in the configuration menu

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cardiowise XRCISE Care Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cardiowise XRCISE Care

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info