Bedienungsanleitung Carrera 160005 (Seite 10 von 60) (Alle Sprachen)

550677

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

 

















Auaden des Akkus

Einsetzen des Akkus

Einsetzen des 9V-Blocks



Charging the rechargeable battery Now you can drive the car

Installing the rechargeable battery

Inserting the 9 V block battery

Let’s practise!



If the Carrera RC vehicle is found to pull

towards the left or right while moving,

use the adjuster control shown in the

illustration to adjust the car’s track pre-

cision.

When the battery is properly connected and

charging normally, the red LED is constantly

lit. Once the battery is fully charged, the red

LED switches to green. The battery can now

be disconnected and installed in the Carrera

RC car.

The car is now ready for use.

Using a screwdriver, remove the cover of the

battery compartment in the Carrera RC car.

Connect the end of the cable from the Car-

rera RC vehicle with the charged battery. Put

the battery in place.

Replace the compartment cover using

a screwdriver.

Unscrew the cover of the battery compart-

ment in the controller and insert the 9 V

block battery.

Now it’s time to practise! Set up a Car-

rera RC vehicle racing track in a large

empty area, using cornerposts, empty

cans, or similar objects. The basic tech-

nique to adopt when operating a Car-

rera RC is to drive fast on the straight

sections and to slow down in the

curves.

When inserting the 9 V block battery, ensure

that the polarity is correct. Replace the cover

using a screwdriver.

First connect the Carrera RC rechargeable

battery to the battery charger supplied. The

connection terminals between the battery

and the charger are designed to prevent

connection with the wrong polarity. Connect

the charger to a power source.

Make sure that nobody in your vicinity

is using the same frequency.

To avoid this and to ensure that your

vehicle will receive the signal from your

controller, make sure that both your car

and the controller are set to the same

frequency (A/B/C).

The use of dierent channels allows

three vehicles to be operated at the

same time.

Pull out the antenna of the controller to

its full extent.

Switch on the Carrera RC car using the

ON/OFF switch. Your Carrera RC car

has two speeds.

The ON/OFF switch is also used to

select the training or indoor mode.

• 

• 

• 

• 

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Carrera 160005 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info