Bedienungsanleitung Carrera 160112 (Seite 7 von 48) (Alle Sprachen)

550861

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Contents of package

1 x Carrera RC Vehicle

1 x Controller

1 x Battery Charger

1 x Rechargeable Battery

1 x Antenna

2 x 1.5 V Micro AAA batteries

(non-rechargeable)

Mounting the antenna

Push the antenna cable through the antenna

tube and then mount this to the Carrera RC ve-

hicle. Secure the end of the antenna cable with a

Carrera RC sticker from the logo sheet.

Charging the rechargeable battery

Place the Carrera RC rechargeable battery in the

Carrera RC charging unit supplied.

Ensure the polarity is correct. Make sure you only

use the Carrera RC charger unit to charge the

3,7 V Li-ion battery supplied.

WARNING! If you try to charge any other re-

chargeable battery or any primary cells such

as AA (LR6, R6P) or AAA (LR3, R3P) batteries

with the Carrera RC charger unit, this may

cause serious damage.

Connect the charger to a power source.

When the battery is put in place correctly and

charging is proceeding normally, the little red LED

lamp will be lit constantly. Once the battery is fully

charged, the LED will no longer be lit. The bat-

tery can now be disconnected and installed in the

Carrera RC car. The car is now ready for use.

Always recharge the battery after use to pre-

vent its becoming deep discharged. After use,

the battery must be allowed to cool down for

at least 20 minutes before it can be fully re-

charged. Failure to observe thispause may

damage the battery. Recharge the battery oc-

casionally (suggested every 2-3 months).

Failure to treat the battery as described above

can lead to its becoming defective.

Installing the rechargeable battery

Using a screwdriver, remove the cover of the bat-

tery compartment in the Carrera RC car.

Place the Carrera RC battery in the vehicle.

Ensure the polarity is correct.Replace the com-

partment cover using a screwdriver.

Inserting the batteries

Open the battery compartment with a screwdriver

and insert the batteries in the remote control.

En-

sure the polarity is correct.Replace the compart-

ment cover using a screwdriver.

Now you can drive the car

Make sure that nobody in your vicinity is using the

same frequency.

Pull out the antenna of the controller to its full extent.

Switch on the Carrera RC car using the ON/OFF

switch.

Adjusting the steering

If the Carrera RC vehicle is found to pull towards

the left or right while moving, use the adjuster

control shown in the illustration to adjust the car’s

track precision.

Let’s practise!

Warning! This vehicle reaches high speeds!

Practice on an empty surface at least 2.5 metres

(8.2’) square. When ﬁrst starting, be very care-

ful when operating the gas pedal.

Now it’s time to practise! Set up a Carrera RC

vehicle racing track in a large empty area, us-

ing cornerposts, empty cans, or similar objects.

The basic technique to adopt when operating a

Carrera RC is to drive fast on the straight sections

and to slow down in the curves.

• When changing from the ﬁrst battery to the

second battery, you must stop running for

at least ten minutes. At the next change, a

pause of at least 20 minutes is absolutely es-

sential.

• Avoid constant motor operation.

• If the car switches itself oﬀ several times one

after another, the battery is dead. Please re-

charge the battery.

• To switch oﬀ after use, follow the steps in

the reverse order.

• After use, remove or disconnect the bat-

tery. Always recharge the battery after use

to prevent its becoming deep discharged.

After use, the battery must be allowed to

cool down for at least 20 minutes before it

can be fully recharged.

• Always keep the rechargeable battery stored

outside the vehicle.

• Clean the Carrera RC car after use.

Controller functions

Full Function

You can steer the car in any direction using the

joysticks:

Joystick on left: forwards/backwards

Joystick on right: left/right

The LED on the controller lights as soon as you

move one of the two joysticks up or down, left or

right.

If you do not touch one of the joysticks, the LED is

not lit, irrespective of whether the ON/OFF switch

is set at ON or OFF.

Troubleshooting

Problem

Car does not move.

Cause: Either the switch on the controller or the car is set

to OFF.

Solution: Switch on

Cause: There is no rechargeable battery in the car or the

battery is too weak.

Solution: Insert charged battery

Cause:

The car has come to a stop at an obstacle.

Solution: The voltage surge protector has switched the car

oﬀ. Turn the ON/OFF switch on the car to OFF, then back to

ON, and place the car on a clear surface.

Cause:

The battery or rechargeable battery in the transmitter

or model is too weak.

Solution: Insert new battery or recharged battery.

Cause:

When it was last used, the model was not switched oﬀ,

and the battery is discharged.

Solution:

Please recharge the battery.

Cause: The vehicle is very warm.

Solution: Switch both car and controller oﬀ and allow the

car to cool down for about 30 minutes.

Problem

Car cannot be controlled.

Cause: Vehicle starts moving unintentionally.

Solution: First turn on the transmitter, only then the vehicle.

Cause: Transmitter antenna is defective.

Solution: Extend the antenna fully.

For the latest version of these operating instructions

and information on replacement and spare parts avail-

able, please visit carrera-rc.com in the service area.

Errors and changes excepted

Colours / ﬁnal design – changes excepted

Technical changes and design-related changes excepted

Pictograms = symbolic photos

ENGLISH

Carrera 160112 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info