Bedienungsanleitung Carrera 162056 (Seite 7 von 48) (Alle Sprachen)

550843

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Contents of package

1 x Carrera RC Vehicle

1 x Controller

1 x Lanyard

1 x Battery Charger

1 x Rechargeable Battery

2 x 1.5 V Mignon AA batteries

(non-rechargeable)

Charging the rechargeable battery

First connect the Carrera RC rechargeable bat-

tery to the battery charger supplied. The connec-

tion terminals between the battery and the charg-

er are designed to prevent connection with the

wrong polarity. Connect the charger to a power

source.

When the battery is properly connected and

charging normally, the red LED is constantly lit.

Once the battery is fully charged, the red LED

switches to green. The battery can now be dis-

connected and installed in the Carrera RC car.

The car is now ready for use. After use, the bat-

tery must be allowed to cool down for at least 20

minutes before it can be fully recharged. Failure to

observe thispause may damage the battery.

Always recharge the battery immediately after

use to prevent its becoming deep discharged.

Recharge the battery occasionally (suggested

every 2-3 months). Failure to treat the battery

as described above can lead to its becoming

defective. Rechargeable batteries are only to

be charged by adults.

Installing the rechargeable battery

Using a screwdriver, remove the cover of the bat-

tery compartment in the Carrera RC car.

Connect the end of the cable from the Carrera RC

vehicle with the charged battery. Put the battery

in place. Replace the compartment cover using a

screwdriver.

Inserting the batteries

Open the battery compartment with a screwdriver

and insert the batteries in the remote control. Ple-

ase keep in mind the correct polarity. Diﬀerent ty-

pes of batteries or new and used batteries are not to

be mixed. After having closed the compartment

you can check all functions of the remote control

with the help of the power-switch on the front.

With the power-switch turned ON and proper

functioning, the top center LED on the remote

control will light up red.

Now you can drive the car

The Carrera RC car and the remote control are

bound as a factory setting.

1. Switch the car ON at the ON/OFF switch. The

LED on top of the car will ﬂash rhythmically.

2. Switch on the controller. The LED on top of the

controller will ﬂash rhythmically.

After a few seconds, the LEDs on the car and on

the controller will light continuously, meaning the

bind has been made.

Adjusting the steering

If the Carrera RC vehicle is found to pull towards

the left or right while moving, use the adjuster

control shown in the illustration to adjust the car’s

track precision.

Let’s practise!

Warning! This vehicle reaches speeds up to

20 km/h (13 mph). Practice on an empty surface

at least 2.5 metres (8.2’) square. When ﬁrst

starting, be very careful when operating the

gas pedal.

Now it’s time to practise! Set up a Carrera RC

vehicle racing track in a large empty area, us-

ing cornerposts, empty cans, or similar objects.

The basic technique to adopt when operating a

Carrera RC is to drive fast on the straight sections

and to slow down in the curves.

• When changing from the ﬁrst battery to the

second battery, you must stop running for

at least ten minutes. At the next change, a

pause of at least 20 minutes is absolutely es-

sential.

• Avoid constant motor operation.

• If the car switches itself oﬀ several times one

after another, the battery is dead. Please re-

charge the battery.

• After 30 minutes inactivity, the controller

and vehicle switch oﬀ automatically. To re-

start, switch the ON/OFF switch on the con-

troller & the car to OFF and then back to ON.

• To switch oﬀ after use, follow the steps in

the reverse order.

• After use, remove or disconnect the battery.

Always recharge the battery immediately

after use to prevent its becoming deep dis-

charged.

• Always keep the rechargeable battery stored

outside the vehicle.

• Clean the Carrera RC car after use.

Controller functions

SERVO TRONIC

You can use the joysticks to carry out precise

steering and driving manoeuvres.

Left joystick: forwards and backwards at dif-

ferent speeds. Please note that the vehicle runs

faster forwards than it does backwards.

Right joystick: steering right and left with variab-

le lock for precise steering

Thanks to 2.4 GHz technology, up to 16 cars can

be run together on one race-track. This is possib-

le even without harmonising frequencies between

the racing drivers.

The joysticks are removable. Alternatively, the ve-

hicle can be controlled with a rocker. The joysticks

can be stored in the special compartment at the

back of the controller.

Attach the lanyard to the eyelet on the controller

and let the controller hang from your neck.

Warning! Danger of strangulation!

Troubleshooting

Problem

Car does not move.

Cause: Either the switch on the controller or the car is set

to OFF.

Solution: Switch on

Cause: There is no rechargeable battery in the car or the

battery is too weak.

Solution: Insert charged battery

Cause:

The car has come to a stop at an obstacle.

Solution: The voltage surge protector has switched the car

oﬀ. Turn the ON/OFF switch on the car to OFF, then back to

ON, and place the car on a clear surface.

Cause:

The battery or rechargeable battery in the transmitter

or model is too weak.

Solution: Insert new battery or recharged battery.

Cause:

The remote control is possibly not correctly frequency

bound with the receiver on the model

Solution: Carry out a frequency bind between the model

and the remote control as described in “Now you can drive

the car”

Cause: The transmitter has switched itself oﬀ after 30 mi-

nutes.

Solution: To restart, switch the ON/OFF switch on both con-

troller & vehicle to OFF and then back to ON..

Cause:

The vehicle is very warm.

Solution:

Switch both car and controller oﬀ and allow the car

to cool down for about 30 minutes.

Cause: The overheat protection has caused the car’s motor

to cut out due to excess temperature.

Solution: Switch off the receiver. Leave the RC car to

cool down for approx. 30 minutes.

Problem

Car cannot be controlled.

Cause: Vehicle starts moving unintentionally.

Solution: First turn on the transmitter, only then the vehicle.

For the latest version of these operating instructions

and information on replacement and spare parts avail-

able, please visit carrera-rc.com in the service area.

Errors and changes excepted

Colours / ﬁnal design – changes excepted

Technical changes and design-related changes excepted

Pictograms = symbolic photos

ENGLISH

Carrera 162056 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info