Bedienungsanleitung Carrera 800025 (Seite 11 von 68) (Alle Sprachen)

551126

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

7 11

5 9

6 10

2 3

OFF

Problem Cause Solution

The Lap Counter is not

working

No battery, or too weak a battery, in the Lap Counter

Replace the batteries in the Lap Counter. Make sure you switch oﬀ the

Lap Counter after using it (page 11, Fig. 12)

The Lap Counter has a temporary malfunction

Press the small round “Soft Reset” button above the button on the

traﬃc light module

Wrong lap number shown on

the controller display

Another participant has set a greater number of laps than you have

Check the controllers of all the participants as described on page 10.

Alter the number of laps on the participants’ controllers to a lower

ﬁgure than that shown on the ﬁrst controller

The lap number on the

controller is not changing

The sensor on the car is dirty

Please clean the sensor, which is located on the underneath of the car

between the front wheels

The ribbon ﬁbre-optic cable is dirty Clean the ribbon ﬁbre-optic cable

The ribbon ﬁbre-optic cable is not correctly connected to the Lap

Counter modules

Check the connection of the ribbon ﬁbre-optic cable with the Lap

Counter modules (page 10)

The controller does not switch

over to race mode

No battery, or too weak a battery, in the Lap Counter Replace the batteries in the Lap Counter

The Lap Counter is not in running lights mode

Start the running lights mode as described on page 11 (see page 11,

Figs 5-7)

The Lap Counter has a temporary malfunction

Press the small round “Soft Reset” button above the button on the

traﬃc light module

Errors and changes excepted

Colours / ﬁnal design – changes excepted

Technical changes and design-related changes excepted

Pictograms = symbolic photos

Now switch on the previously programmed

controller and the display switches auto-

matically into RACE mode. Any other con-

troller within range will now log on automati-

cally, so make sure that when you switch on

the ﬁrst controller, there are no other con-

trollers switched on. Now all the other com-

petitors in the race can switch on their con-

trollers. Check the number of participants.

Switch the Carrera RC Lap Counter

on at the left-hand side of the traﬃc

light module.

Press once on the button on the traﬃc

light module.

Once all participants are logged on,

press once again on the button on the

traﬃc light module (about 3 seconds)

and the starting sequence commences.

As soon as the traﬃc light changes to

green, the race can start.

On the display you will now see the

race time and your position, each time

you cross the start-ﬁnish line, as well as

your fastest lap.

For a new start, press the button on the

traﬃc light module for one second so

that the traﬃc light switches into run-

ning mode again (see Fig. 7).

After the race, always switch oﬀ the

model ﬁrst, then the controller and Lap

Counter.

The light switches into running light

mode and starts to look for participants.

Troubleshooting

Should you need spare parts, you will ﬁnd a complete list of the available parts under carrera-rc.com in the service area.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Carrera 800025 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info