Bedienungsanleitung Carrier 42ADF025 (Seite 8 von 45) (Alle Sprachen)

481319

Zoom out

Zoom in

Vorherige Seite

1/45

Nächste Seite

The hexagon wrench

is required.

Packed valve handling precautions

• Open the valve stem all the way out, but do not try to open it beyond

the stopper.

• Securely tighten the valve stem cap with torque in the following table:

Wiring Connection

1. Remove the valve cover from the outdoor unit.

2. Connect the connecting cable to the terminals as identified with their

respective matched numbers on the terminal block of indoor and

outdoor unit.

3. When connecting the connecting cable to the outdoor unit terminals,

make a loop as shown in the installation diagram of indoor and

outdoor unit to prevent water coming in the outdoor unit.

4. Insulate the unused cords (conductors) from any water coming in the

outdoor unit. Proceed them so that they do not touch any electrical or

metal parts.

Stripping length of the connecting cable

CAUTION

• Wrong wiring connection may cause some electrical parts burn out.

• Be sure to comply with local cords on running the wire from indoor

unit to outdoor unit (size of wire and wiring method, etc.).

• Every wire must be connected firmly.

• This installation fuse (25A) must be used for the power supply line

of this air conditioner.

• If incorrect or incomplete wiring is carried out, it will cause an

ignition or smoke.

• Prepare the power supply for exclusive use with the air conditioner.

• This product can be connected to the mains.

Connection to fixed wiring: A switch which disconnects all poles

and has a contact separation of at least 3 mm must be

incorporated in the fixed wiring.

NOTE : Connecting cable

• Wire type : More than H07RN-F or 245 IEC66

Gas side 30 to 42 N·m

(∅9.52 mm) (3.0 to 4.2 kgf·m)

Liquid side 16 to 18 N·m

(∅6.35 mm) (1.6 to 1.8 kgf·m)

Service port

9 to 10 N·m

(0.9 to 1.0 kgf·m)

Gas Leak Test

Check places for

the outdoor unit.

Electric parts cover

Valve cover

• Check the flare nut connections for the gas leak with a gas leak

detector or soap water.

OTHERS

Model 38VYX025-R 38VYX035-R

Power source 50/60 Hz, 220 – 240 V Single phase

Maximum running current 8A 11A

Plug socket & fuse rating 25A

Power cord H07RN-F or 245 IEC66 (1.5 mm

or more)

Check places for

the indoor unit.

When two indoor units are installed in the separated rooms, it

is not necessary to change the selector switches.

Remote control selector switch

• When two indoor units are installed in the same room or

adjacent two rooms, if operating a unit, two units may receive

the remote control signal simultaneously and operate. In this

case, the operation can be preserved by setting either one

indoor unit or remote control to B setting. (Both are set to A

setting in factory shipment.)

• The remote control signal is not received when the settings of

indoor unit and remote control are different.

• There is no relation between A setting/B setting and A room/B

room when connecting the piping and cables.

Setting of Remote Control

Selector Switch

L3N

Connecting cable

Earth line

GB - 4

Connecting cable

Earth lin

Terminal block

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Carrier 42ADF025 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Carrier 42ADF025

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info