727556
18
Zoom out
Zoom in
Vorherige Seite
1/72
Nächste Seite
- Dismount the unit following the steps on moun-
ting but afterwards.
- Ensure cables are not trapped when stroing.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.
If any anomaly is detected, check the following table.
No deter-
gent suction
Units with tanks
Lance nozzle is not in ow
pressure mode
Slide lance nozzle into low pressu-
re position
High pressure extension
hose or high pressure hose is
too long
Remove high pressure extension
hose shorter than 7,5 m
Injector is clogged on pump
Bring the appliance to any custo-
mer serrvice
Units with
attachable
applicators
Detergent applicator is
clogged
Clean applicator with warm water.
If it not works, replace the appli-
cator
Pressure washer does not
start up
Unit is pressurized Squeeze trigger on gun
Plug is not well connected or
electric socket is faulty
Check plug, pocket and fuse
Extension cord is too long or
wire size too small
Remove extension cord
Main voltage supply is too
low
Check the voltage in the main
supply match the voltage indicated
on the Rating Label
Thermal safety switch has
tripped
Switch off unit and allow motor to
cool down
Pump does not reach the
necessary pressure
Water inlet lter is clogged Clean water inlet lter
Pump is sucking air from
hose connections
Check that connections and loc-
king ring are properly tightened
Nozzle is worn or not correct Bring the appliance to any custo-
mer service
Unloader is clogged or worn
Valves are clogged or worn
Fluctuating pressure
Pump is sucking air from
hose connections
Check that connections and loc-
king ring are properly tightened
Clogged nozzle
Clean the nozzle with the typ
cleaner.
Valves are dirty, worn or
stuck
Bring the appliance to any custo-
mer service
Water seals worn
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Casals JHP18 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info