624477
5
Zoom out
Zoom in
Vorherige Seite
1/9
Nächste Seite
Operation Guide 5110
E-40
Alarms
When an alarm is turned on, the alarm tone will sound
when its alarm time is reached. One of the alarms is a
snooze alarm, while the other four are one-time alarms.
You also can turn on an Hourly Time Signal that causes
the watch to beep twice every hour on the hour.
There are fi ve alarm screens numbered
AL1
,
AL2
,
AL3
and
AL4
for the one-time alarm, and a snooze
alarm screen indicated by
SNZ
. The Hourly Time
Signal screen is indicated by
SIG
.
All of the operations in this section are performed in
the Alarm Mode, which you enter by pressing
C
(page E-9).
Alarm time
(Hour : Minutes)
Alarm number
E-41
To set an alarm time
1. In the Alarm Mode, use
D
to scroll through the alarm
screens until the one whose time you want to set is
displayed.
To set a one-time alarm, display alarm screen AL1,
AL2, AL3 or AL4. To set the snooze alarm, display
the SNZ screen.
SIG is the hourly time signal setting (page E-44).
The snooze alarm repeats every fi ve minutes.
2. After you select an alarm, hold down
A
for about three seconds until the hour
setting of the alarm time starts to fl ash. This is the setting mode.
This operation turns on the alarm automatically.
3. Press
C
to move the fl ashing between the hour and minute settings.
E-42
4. While a setting is fl ashing, use
D
(+) and
B
(–) to change it.
5. Press
A
to exit the setting mode.
Alarm Operation
The alarm tone sounds at the preset time for 10 seconds, regardless of the mode the
watch is in. In the case of the snooze alarm, the alarm operation is performed a total
of seven times, every fi ve minutes, or until you turn the alarm off (page E-43).
Alarm and Hourly Time Signal operations are performed in accordance with the
current time in your Home City, as kept in the Timekeeping Mode.
To stop the alarm tone after it starts to sound, press any button.
Performing any one of the following operations during a 5-minute interval between
snooze alarms cancels the current snooze alarm operation.
Displaying the Timekeeping Mode setting screen (page E-58)
Displaying the
SNZ
setting screen (page E-41)
E-43
To turn an alarm on and off
1. In the Alarm Mode, use
D
to select an alarm.
2. Press
A
to toggle it on and off.
Turning on a alarm (
AL1
,
AL2
,
AL3
,
AL4
or
SNZ
)
displays the alarm on indicator on its Alarm Mode
screen.
In all modes, the alarm on indicator is shown for any
alarm that currently is turned on.
The alarm on indicator fl ashes while the alarm is
sounding.
The snooze alarm indicator fl ashes while the snooze
alarm is sounding and during the 5-minute intervals
between alarms.
Alarm on
indicator
ON
Snooze alarm indicator
E-44
To turn the Hourly Time Signal on and off
1. In the Alarm Mode, use
D
to select the Hourly Time
Signal (
SIG
) (page E-41).
2. Press
A
to toggle it on and off.
The Hourly Time Signal on indicator is shown on the
display in all modes while this function is turned on.
Hourly time signal
on indicator
E-45
Illumination
An LED (light-emitting diode) illuminates the face of the
watch for easy reading in the dark. The watch’s auto light
switch turns on illumination automatically when you angle
the watch towards your face.
The auto light switch must be turned on (indicated by
the auto light switch on indicator) for it to operate.
See “Illumination Precautions” (page E-73) for other
important information about using illumination.
To illuminate the display manually
In any mode (except a setting mode), press
B
to turn on
the illumination for about one second.
The above operation turns on illumination regardless
of the current auto light switch setting.
Auto light switch
on indicator
E-46
About the Auto Light Switch
Turning on the auto light switch causes illumination to turn on, whenever you position
your wrist as described below in any mode.
Note that this watch features a “Full Auto LED Light”, so the auto light switch operates
only when available light is below a certain level. It does not illuminate the display
under bright light.
The auto light switch is always disabled, regardless of its on/off setting, when any
one of the following conditions exists.
-While an alarm is sounding
-While a signal receive operation is in progress
E-47
Moving the watch to a position that is parallel to the ground and then tilting it
towards you more than 40 degrees causes illumination to turn on.
Wear the watch on the outside of your wrist.
Parallel to
ground
More than
40°
E-48
Warning!
Always make sure you are in a safe place whenever you are reading the
display of the watch using the auto light switch. Be especially careful when
running or engaged in any other activity that can result in accident or injury.
Also take care that sudden illumination by the auto light switch does not
startle or distract others around you.
When you are wearing the watch, make sure that its auto light switch is turned
off before riding a bicycle or operating a motorcycle or any other motor
vehicle. Sudden and unintended operation of the auto light switch can create
a distraction, which can result in a traffi c accident and serious personal injury.
To turn the auto light switch on and off
In the Timekeeping Mode, hold down
B
for about three seconds to toggle the auto
light switch on (auto light switch on indicator displayed) and off (auto light switch on
indicator not displayed).
The auto light switch on indicator is on the display in all modes while the auto light
switch is turned on.
E-49
Power Supply
This watch is equipped with a solar panel and a special rechargeable battery
(secondary battery) that is charged by the electrical power produced by the solar
panel. The illustration shown below shows how you should position the watch for
charging.
Example:
Orient the watch so its face is
pointing at a light source.
The illustration shows how to position
a watch with a resin band.
Note that charging effi ciency drops
when any part of the solar panel is
blocked by clothing, etc.
You should try to keep the watch
outside of your sleeve as much as
possible. Charging is reduced
signifi cantly if the face is even only
partially covered.
Solar panel
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

casio-5110

Suche zurücksetzen

  • wie stelle ich die analog Zeiger syncron zur digital Anzeige? Eingereicht am 3-8-2018 12:49

    Antworten Frage melden
  • Wie stellt man die Uhrzeit von 12 Stunden auf 24 Stunden anzeige Eingereicht am 3-7-2018 15:03

    Antworten Frage melden
  • analogezeit stimmt nicht mit der digitalzeit überein Eingereicht am 28-3-2018 17:17

    Antworten Frage melden
  • wie Stelle hat anstelle der englischen Datumsanzeige das Datum in deutsch ein? Eingereicht am 6-3-2018 12:26

    Antworten Frage melden
  • was bedeuten die Buchstaben D und T auf dem hilfszifferblatt Eingereicht am 23-7-2017 13:41

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Casio 5110 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Casio 5110

Casio 5110 Bedienungsanleitung - Deutsch - 9 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info