Bedienungsanleitung Casio 5240 (Seite 1 von 9) (Englisch)

607041

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

Operation Guide 5240

E-9

E-30 Mode Reference Guide

E-31 To determine the watch’s current mode

E-31 To return to the Timekeeping Mode from any other mode

E-32 To select a mode

E-33 Timekeeping

E-34 Conﬁ guring Home City Settings

E-34 To conﬁ gure Home City settings

E-37 To switch between standard time and summer time manually

E-39 Conﬁ guring Current Time and Day Settings Manually

E-39 To change the current time setting manually

E-42 To change the current day setting manually

E-46 Thermometer

E-47 To take a temperature reading

E-48 To switch a temperature reading unit between Celsius (°C) and

Fahrenheit (°F)

E-8

Contents

E-2 About This Manual

E-3 Using the Crown

E-3 To lock the crown

E-4 To unlock the crown

E-4 To pull out, rotate, or push the crown in

E-6 Things to check before using the watch

E-12 Charging the Watch

E-17 To recover from the sleep state

E-18 Radio Controlled Atomic Timekeeping

E-23 To get ready for a receive operation

E-26 To perform manual receive

E-27 To check the result of the latest receive operation

E-28 To turn auto receive on and off

E-7

2. Check the Home City.

Use the procedure under “To conﬁ gure Home City settings” (page E-34) to conﬁ gure

your Home City.

Important!

Proper time calibration signal reception depends on correct Home City, time, and

day settings in the Timekeeping Mode. Make sure you conﬁ gure these settings

correctly.

3. Set the current time.

x To set the time using a time calibration signal

See “To get ready for a receive operation” (page E-23).

x To set the time manually

See “Conﬁ guring Current Time and Day Settings Manually” (page E-39).

The watch is now ready for use.

For details about the watch’s radio controlled timekeeping feature, see “Radio x

Controlled Atomic Timekeeping” (page E-18).

E-6

Things to check before using the watch

1. Hold down C at least two seconds to enter the Timekeeping Mode, and

then observe the movement of the

Second Hand.

Is the

Second Hand moving smoothly at one-second intervals?

Is the

Second Hand moving at

two-second intervals or is it stopped

completely?

Go to step 2.

The watch is charged. For details

about charging, see “Charging

the Watch” (page E-12).

Power is low. Charge the watch by

placing it in a location where it is

exposed to light. For details, see

“Charging the Watch” (page E-12).

YES

E-5

High-speed 1 High-speed 2 High-speed Cancel

With the crown pulled out,

rotate it rapidly away from

you three times.

After starting the High-

speed 1 operation, rotate

the crown rapidly away

from you three more times.

Rotate the crown towards

you or press any button.

Note

If you do not perform any operation for more than two minutes after pulling out the

crown, crown operations will become disabled automatically. If this happens, push

the crown back in and then pull it out again to re-enable crown operations.

You can use high-speed hand movement when conﬁ guring time settings in the

Timekeeping Mode, Alarm Mode, or Countdown Timer Mode.

High-speed hand movement is forward only. There is no high-speed backward x

hand movement.

E-4

To unlock the crown

Rotate the crown so the groove aligns with Mark 1.

To pull out, rotate, or push the crown in

Important!

Before performing any of these operations, ﬁ rst unlock the crown.

The illustrations below show the different crown operations.

Pull out Rotate Push in

When rotating the crown to move the hands of the watch, you can use the operations

described below to move the hands at high speed. There are two high-speed hand

movement speeds. High-speed 2 is the fastest.

E-3

Using the Crown

This watch has a lock-type crown.

Important!

You should normally have the crown locked during normal daily use. Leaving the crown

unlocked creates the risk of unintended operations or even damage due to impact.

To lock the crown

Push the crown back in (see “To pull out, rotate, or push the 1.

crown in” below).

Note that attempting to lock the crown when it is not

pushed in can cause unexpected watch operation.

Rotate the crown so the groove is aligned with Mark 1.2.

While pushing in on the crown (a), rotate it to the right (b) so 3.

the groove aligns with Mark 2.

Gently pull on the crown to make sure it is securely locked 4.

and does not come out.

Mark 1

Groove

Mark 2

E-2

About This Manual

Operations are performed using the watch’s crown, and

the three buttons indicated by the letters A, B and C in

this manual.

Hands and Indicators

Hour Hand

Second Hand

Minute Hand

Upper Dial Hand: Indicates a time, in 24-hour format,

depending on the current mode.

Lower Dial Hand: Indicates the current mode.

Day Indicator

This User’s Guide uses numbers shown above to identify

watch hands and indicator.



@>B

E-1

ENGLISH

Congratulations upon your selection of this CASIO watch.

Note that the product illustrations in this manual are intended for reference only, and so

the actual product may appear somewhat different than depicted by an illustration.

This watch does not have a city code that corresponds to the UTC offset of –3.5

hours. Because of this, the radio-controlled atomic timekeeping function will not

display the correct time for Newfoundland, Canada.

Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any

damage or loss suffered by you or any third party arising through the use of this

product or its malfunction.

MA1307-EC

#!3)/#/-054%2#/,4$

Casio 5240 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio 5240

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info