Bedienungsanleitung Casio 5454 - OCW-G1100 (Seite 7 von 13) (Englisch)

624830

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

Checking the Receive

Operation Result

You can use the procedure below to check the

result

of the last GPS or time calibration signal

receive operation.

Getting ready

Enter the Timekeeping Mode.

l Navigating Between Modes

Press (B).

The second hand will move and indicate

the receive operation result.

“Y (YES)”: Receive successful

“N (NO)”: Receive failed

The mode hand indicates details about

the receive (acquisition) operation.

“P”: Time information and position

information (GPS signal)

“N”:

Time information (GPS signal) or time

calibration signal

Second hand

Press

(B) or do not perform any operation

for one or two seconds to return to the

current time.

Note

●

Even if there was a successful

receive operation, the second hand

will point to “N (NO)” if you adjusted

the time setting manually.

Signal Reception

Precautions

●

When the watch is unable to adjust its time

in accordance with a calibration signal for

some reason, average timekeeping

accuracy is within ±15 seconds per month.

●

Time signal reception is not possible when

any one of the conditions exists.

ー

While battery power is low

ー

While the watch is in the Airplane Mode

or Stopwatch Mode

ー

When power saving is at Level 2 (GPS

signal reception also is not possible at

Level 1.)

ー

While the crown is pulled out

ー

While the temperature of the watch is less

than approximately -10°C (14°F) or

greater than approximately 60°C (140°F)

●

Note that an internal decoding process the

watch

performs after it receives a signal may

cause the time setting to be slightly off (by

less than one second).

●

If the receive operation is successful, the

time and day settings will be adjusted

automatically in accordance with the Home

City (time zone) and summer time settings.

Summer

time will not be applied correctly in

the cases described below.

ー

When the summer time start date and

time, end date and time, or other rules are

changed by authorities

ー

When position information cannot be

acquired correctly

ー

When position information can be

acquired, but it is wrong because the

watch is located near a time zone

boundary, etc.

●

As of July 2015, China does not observe

summer time. If China starts to observe

summer time in the future, the time

displayed

by the watch for China may not be

correct.

Using the Watch on an

Aircraft

Enter the Airplane Mode when in an aircraft or

anywhere else where GPS or time calibration

signal reception is restricted.

Entering the Watch Airplane

Mode

Holding down (C) for about four seconds to

enter the watch’s Airplane Mode. The mode

hand will move to the Airplane mark.

Airplane mark

●

Each time (C) is held down for about four

seconds, the watch enters or exits the

Airplane Mode.

World Time

World Time lets you look up the current time

in any one of 27 cities and 40 time zones

around the globe.

Getting ready

Enter the Timekeeping Mode.

l Navigating Between Modes

Operation Guide 5454

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Casio 5454 - OCW-G1100 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio 5454 - OCW-G1100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info