Operation Guide 5416
E-29
Temperature
x Never leave your watch on the dashboard of a car, near a heater, or in any other
location that is subject to very high temperatures. Do not leave your watch where
it will be exposed to very low temperatures. Temperature extremes can cause your
watch to lose or gain time, to stop, or otherwise malfunction.
x
to problems with its LCD. The LCD may become difficult to read at temperatures
lower than 0°C (32°F) and greater than +40°C (104°F).
Impact
x Your watch is designed to withstand impact incurred during normal daily use and
during light activity such as playing catch, tennis, etc. Dropping your watch or
otherwise subjecting it to strong impact, however, can lead to malfunction. Note
that watches with shock-resistant designs (G-SHOCK, BABY-G, G-MS) can be
worn while operating a chain saw or engaging in other activities that generate
strong vibration, or while engaging in strenuous sports activities (motocross, etc.)
E-28
Band
x Tightening the band too tightly can cause you to sweat and make it difficult for air
to pass under the band, which can lead to skin irritation. Do not fasten the band too
tightly. There should be enough room between the band and your wrist so you can
insert your finger.
x Deterioration, rust, and other conditions can cause the band to break or come off
of your watch, which in turn can cause band pins to fly out of position or to fall out.
This creates the risk of your watch falling from your wrist and becoming lost, and
also creates the risk of personal injury. Always take good care of your band and
keep it clean.
x Immediately stop using a band if you even notice any of the following: loss of band
flexibility, band cracks, band discoloration, band looseness, band connecting
pin flying or falling out, or any other abnormality. Take your watch to your original
retailer or to a CASIO service center for inspection and repair (for which you will be
charged) or to have the band replaced (for which you will be charged).
E-27
x A trained technician will inspect your watch for proper water resistance whenever
you have its battery replaced. Battery replacement requires the use of special tools.
Always request battery replacement from your original retailer or from an authorized
CASIO service center.
x Some water-resistant watches come with fashionable leather bands. Avoid
swimming, washing, or any other activity that causes direct exposure of a leather
band to water.
x The inside surface of the watch glass may fog when the watch is exposed to a
sudden drop in temperature. No problem is indicated if the fogging clears up
relatively quickly. Sudden and extreme temperature changes (such as coming into
an air conditioned room in the summer and standing close to an air conditioner
outlet, or leaving a heated room in the winter and allowing your watch to come into
contact with snow) can cause it to take longer for glass fogging to clear up. If glass
fogging does not clear up or if you notice moisture inside of the glass, immediately
stop using your watch and take it to your original retailer or to an authorized CASIO
service center.
x Your water-resistant watch has been tested in accordance with International
Organization for Standardization regulations.
E-26
x Watches that do not have WATER RESIST or WATER RESISTANT marked on
the back cover are not protected against the effects of sweat. Avoid using such
a watch under conditions where it will be exposed to large amounts of sweat or
moisture, or to direct splashing with water.
x Even if a watch is water resistant, note the usage precautions described below.
Such types of use reduce water resistance performance and can cause fogging of
the glass.
−
wet.
−
−
high temperature/high humidity environment.
−
housework, or while performing any other task that involves soaps or detergents.
x After submersion in seawater, use plain water to rinse all salt and dirt from your
watch.
x To maintain water resistance, have the gaskets of your watch replaced periodically
(about once every two or three years).
E-25
Water Resistance
x
RESISTANT marked on the back cover.
Water
Resistance
Under Daily
Use
Enhanced Water Resistance Under
Daily Use
5
Atmospheres
10
Atmospheres
20
Atmospheres
Marking On watch front or on
back cover
No
BAR mark 5BAR 10BAR 20BAR
Example of
Daily Use
Hand washing, rain Yes Yes Yes Yes
Water-related work, swimming
No Yes Yes Yes
Windsurfing No No Yes Yes
Skin diving No No Yes Yes
x
Do not use your watch for scuba diving or other types of diving that requires air tanks.
OPUM-E
E-24
Battery:
Approximately 7 years on type CR2016 (assuming alarm operation 20seconds per
day and one illumination operation 2seconds per day)
Frequent use of illumination runs down the battery.
Specifications are subject to change without notice.
E-23
Specifications
Accuracy at normal temperature:
±
15 seconds a month
Calendar:
Calendar system:
Digital Timekeeping:
Time format:
Analog Timekeeping:
Alarm:
Setting units:
Beeper:
Stopwatch:
Measuring unit:
Measuring capacity:
Measuring mode:
Dual Time:
Illumination:
E-22
Illumination
The face of the watch is illuminated for easy reading in
the dark.
To turn on illumination
In any mode (except when a setting mode, with flashing
digits is on the display), press L to illuminate the display.
Illumination Precautions
x Illumination may be hard to see when viewed under direct sunlight.
x Illumination turns off automatically whenever an alarm sounds.
x Frequent use of illumination runs down the battery.
x The watch will emit an audible sound whenever the display is illuminated. This
is caused by a transistor that vibrates when the EL panel lights up. It does not
indicate malfunction of the watch.
E-21
Use the following procedure to adjust the analog hands so their settings match the
digital time.
To adjust the analog time
1. A to advance the analog time
setting by 20seconds.
x Holding down A advances the analog time setting
at high speed.
E-20
3. C to change it.
x While the 12-hour format is selected for digital timekeeping, a P (PM) indicator
will appear for times from noon to 11:59 p.m.
4. B to exit the setting mode.
x In the Dual Time Mode, the seconds count is synchronized with the seconds
count of the digital timekeeping.
