Bedienungsanleitung Casio ctk-50 (Seite 45 von 83) (Englisch)

564684

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

E-43

Press the START/STOP button to end recording

when you are finished playing.

• If you make a mistake while recording, stop the record

operation and begin over again from step 1.

NOTE

• Using real-time recording to record to a track that already

contains recorded data replaces the existing recording

with the new one.

Track 1 Contents After Real-time

Recording

In addition to keyboard notes and accompaniment chords,

the following data is also recorded to Track 1 during real-

time recording. This data is used whenever Track 1 is played

back.

• Tone number

• Rhythm number

• INTRO, SYNCHRO/ENDING, NORMAL/FILL-IN,

VARIATION/FILL-IN button operations

• Pedal operations

Memory Capacity

The keyboard has memory for approximately 5,100 notes. You

can use all 5,100 notes for a single song, or you can divide

memory between two different songs.

• The measure number and note number flash on the display

whenever remaining memory is less than 100 notes.

• Recording automatically stops (and Auto Accompaniment

and rhythm stops playing if they are being used) whenever

memory becomes full.

Memory Data Storage

• Anything previously stored in song memory is replaced

whenever you make a new recording.

• Memory contents are retained as long as the keyboard is

supplied with electrical power. Unplugging the AC adaptor

when batteries are not loaded or when loaded batteries are

dead cuts off the keyboard’s electrical power supply,

causing all data stored in song memory to be deleted. Be

sure to plug the keyboard into an electrical outlet with the

AC adaptor before replacing batteries.

• Turning off the keyboard while a record operation is in

progress causes the contents of the track you are currently

recording to be lost.

Flash

Track 1 Real-time Recording

Variations

The following describes a number of different variations you

can use when recording to Track 1 using real-time recording.

All of these variations are based upon the procedure described

under “To record to Track 1 using real-time recording” on

page E-42.

To record without rhythm

Skip step 5. Real-time recording without rhythm starts when

you press a keyboard key.

To start recording with synchro start

In place of step 5, press the SYNCHRO/ENDING button.

Auto Accompaniment and recording will both start when you

play a chord on the accompaniment keyboard.

To record using an intro, ending, or fill-in

During recording, the INTRO, SYNCHRO/ENDING,

NORMAL/FILL-IN, and VARIATION/FILL-IN buttons

(pages E-38 through E-40) can all be used as they normally

are.

To synchro start Auto Accompaniment with an intro

pattern

In place of step 5, press the SYNCHRO/ENDING button and

then the INTRO button. Auto Accompaniment will start with

the intro pattern when you play a chord on the

accompaniment keyboard.

To start Auto Accompaniment part way into a recording

In place of step 5, press the SYNCHRO/ENDING button and

then play something on the melody keyboard to start. When

you reach the point where you want Auto Accompaniment

to start, play a chord on the accompaniment keyboard.

Song Memory Function

704A-E-045A

CTK591_e_41-45.p65 03.10.7, 4:27 PM43

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Casio ctk-50 Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio ctk-50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info