Bedienungsanleitung Casio CTK-7300IN (Seite 139 von 168) (Englisch)

586786

139

Zoom out

Zoom in

Vorherige Seite

1/168

Nächste Seite

Using a Memory Card

E-138

Use the R-17 (t, y) buttons to move the 0 to

“CardFormat”.

Press the R-16 (ENTER) button.

• This will display a value indicating the maximum

number of audio recordings that can be recorded.

Use the dial or R-14 (–, +) buttons to specify the

number of audio recordings you want to format

the card for.

• You can format a 2GB card for up to 14 songs. A 4GB

to 32GB card can be formatted for up to 20 songs.

• An audio recording area of approximately 128MB is

reserved on the memory card for each song.

• The minimum number of audio recordings you can

specify is 0 (which specifies the card will not be used

for storage of audio recordings).

• The higher the number of audio recordings you specify

here, the longer it will take to format the card.

Press the R-14 (YES) button to format the

memory card or the R-14 (NO) button to cancel.

• The message “Please Wait” will remain on the display

while the format operation is being performed. Do not

perform any Digital Keyboard operation while this

message is on the display. “Complete” appears on the

display after formatting is complete.

• Formatting may take as long as a few minutes to

complete.

Insert the memory card into the card slot.

If the Digital Keyboard is in the card mode,

press the C-9 (CARD) button to exit the card

mode.

Depending on the type of data you want to save

to the memory card, perform one of the steps

shown below.

• All setup registration banks are saved as a batch. Other

data is saved in area (data item) units.

While holding down the R-13 (FUNCTION)

button, press the C-9 (LOAD/SAVE) button.

• This causes an “Xxxx Load”

screen like the one

shown below to appear. The sample screen below

shows the screen that appears from the rhythm screen.

Saving Digital Keyboard Data to a

Memory Card

To save Digital Keyboard data to a memory

card

To save this

type of data:

Do this:

One user rhythm 1. Press the L-8 ([F] USER RHYTHMS)

button.

2. Use the dial or R-14 (–, +) buttons to

specify the user rhythm number.

One user tone 1. Press the R-11 ([K] USER TONES)

button.

2. Use the dial or R-14 (–, +) buttons to

specify the user tone number.

One user

drawbar organ

tone

1. Press the R-12 ([L] DRAWBAR ORGAN)

button.

2. Use the dial or R-14 (–, +) buttons to

specify the user drawbar organ tone

number (L:051 through L:100).

One user DSP 1. Perform steps 1 through 4 under “To use

a DSP” (page E-32).

2. Use the dial or R-14 (–, +) buttons to

specify the user DSP number (101

through 200).

One user preset 1. While holding down the L-6 ([D] INDIAN)

button, press the L-7 ([E] PIANO

RHYTHMS) button to display the music

preset screen.

2. Press the L-8 ([F] USER RHYTHMS)

button.

3. Use the dial or R-14 (–, +) buttons to

specify the user preset number.

One song

sequencer song

1. Press the C-4 (SONG SEQUENCER)

button to enter the song sequencer mode.

2. Use the dial or R-14 (–, +) buttons to

specify the song number.

All registration

banks

Press the C-10 (BANK) button to display the

registration bank selection screen.

CTK7300IN_e.book 138 ページ２０１３年７月１９日　金曜日　午後１２時１分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Casio CTK-7300IN Seite 139

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info