Bedienungsanleitung Casio PX-S3100 (Seite 69 von 96) (Englisch)

781706

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

EN-68

●Nothing happens when I touch a touch button.

●No sound is produced when I press a keyboard key.

●The Digital Piano emits a loud sound and suddenly

turns off.

●The pitch of the Digital Piano is off.

●Nothing happens when I press a pedal.

●Nothing happens when I start an Auto Accompaniment.

Troubleshooting

Cause:

a. Wearing glove or touching with a fingernail or stylus.

b. Incorrect touch button sensitivity setting.

Action:

a. When operating a touch button, touch it firmly with a

bare finger.

b. Perform the steps below to increase touch button

sensitivity.

(1) Turn off the Digital Piano.

(2) While holding down the C8 keyboard key (the one

on the far right), press the 1P (Power) button.

• Keep the C8 keyboard key depressed until the

“Welcome” message appears on the display. You

do not need to keep the 1P (Power) button

depressed.

Cause:

a. The 2 volume knob setting is too low.

b. Headphones or an adaptor plug is plugged into one of

the co PHONES jacks.

c. MIDI Local control is turned off.

d. The Digital Piano is in the Keyboard Controller Mode, so

keys A0 through F1 are functioning as a “controller

keys”.

Action:

a. Rotate the 2 volume knob.

b. Disconnect whatever is connected to the co PHONES

jacks.

c. Turn on the Local control setting (page EN-59).

d. Exit the Keyboard Controller Mode.

Action:

Replace the batteries with new ones or switch over to AC

adaptor power (page EN-5).

Cause:

a. The current transpose setting of the keyboard is

something other than the default setting.

b. The Digital Piano’s tuning setting is something other

than “440.0Hz”.

c. Octave shift is enabled.

d. The current scale setting is something other than “Equal

Temperament”.

Action:

a. Return transpose (page EN-19) to its initial default

setting.

b. Change the tuning setting to “440.0Hz” (page EN-20).

c. Change the octave shift setting to 0 (page EN-20).

d. Change the scale setting to “Equal Temperament”.

Cause:

a. The pedal cord is not connected correctly to the

cr DAMPER PEDAL jack, cs PEDAL UNIT jack, or

dl EXPRESSION/ASSIGNABLE jack, or the plug is

not plugged in completely.

b. The wrong pedal type or function is assigned to the jack

where the pedal is connected.

Action:

a. Confirm that the pedal cord is connected correctly, and

that the plug is inserted as far as it will go.

b. Configure settings correctly. See “DAMPER PEDAL

Jack” (page EN-7) and “EXPRESSION/ASSIGNABLE

Jack” (page EN-8).

Cause:

a. With rhythms 29 to 38 in the BALLAD category, nothing

will sound if you do not play a chord on the keyboard.

b. The Auto Accompaniment volume level is set to 0.

c. Some error occurred.

Action:

a. Try playing a chord on the keyboard (page EN-32).

b. Check the Auto Accompaniment volume level (page

EN-18) and adjust it, if necessary.

c. Try turning the Digital Piano off and then back on again

(page EN-6), which will initialize its settings.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Casio PX-S3100 Seite 69

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio PX-S3100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info