Bedienungsanleitung Casio WK-210 (Seite 14 von 75) (Englisch)

586839

Zoom out

Zoom in

Vorherige Seite

1/75

Nächste Seite

Playing the Digital Keyboard

E-12

After performing melody sampling to tone number 571

through 575, the corresponding tones are replaced with the

samples in Sets 1, 2, and 3 of the voice pads described in the

previous section. For more information about melody

sampling, see page E-20.

• Deleting sampled data will return the Voice Pads to their

default sounds. For more information about deleting

sampled data, see page E-25.

You can use the following procedure to adjust the volume

levels of the voice pad sounds to match them to other sounds

(keyboard, etc.).

Enable the voice pads.

• See steps 1 and 2 of the procedure on page E-11.

While holding down

, hold down the voice

pad (

through

) whose volume you want to

adjust.

• Keep

and the voice pad depressed as you perform

the next step.

Example: To select

(Pad 2).

While still holding down the two buttons, keep

pressing and releasing any keyboard key.

• Each press of the keyboard key will sound the tone

assigned to the voice pad. As you listen to the tone,

adjust its volume by altering the speed at which you are

pressing the keyboard key. Pressing at a faster rate will

raise the volume, while a slower rate will lower the

volume.

After the tone is at the volume you want, release

the two buttons you depressed in step 2.

• You can batch adjust the volume level of more than one

voice pad by holding down more than one voice pad along

with

in step 2 above.

The metronome lets you play and practice along with a steady

beat to help keep you on tempo.

Press

This starts the metronome.

Press

again to stop the metronome.

You can configure the metronome to use a bell sound for the

first beat of each measure of the song you are playing.

• You can specify 0, or a value from 2 to 6 as the number of

beat per measure.

• When playing a built-in song, the beats per measure setting

(which determines when the bell sounds) is configured

automatically for the currently selected song.

Hold down

until the beats per measure

setting screen appears on the display.

• If you do not perform any operation for a few seconds

after the beats per measure setting screen appears, the

display will return to the screen displayed before you

pressed

Use

(10-key) to enter the number of beats

per measure.

• The bell will not sound if you specify 0 for this setting. In

this case, all beats are indicated by a click sound. This

setting lets you practice with a steady beat, without

worrying how many beats there are in each measure.

Sounding Sampled Sounds with the Voice

Pads

Adjusting the Volume Levels of Voice Pads

bt cl

Using the Metronome

Start/Stop

Changing the Beats Per Measure

This pattern changes with each beat.

Bea t

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Casio WK-210 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio WK-210

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info