Bedienungsanleitung Casio WK-3800 (Seite 100 von 108) (Englisch)

466898

100

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

E-98

Troubleshooting

Problem Possible Cause Action See page

The key or tuning does not

match when playing along with

another MIDI machine.

Parts suddenly drop out during

song memory playback.

Some parts do not play at all

during song memory playback.

Nothing happens when the

LAYER or SPLIT button is

pressed.

No sound is produced when

playing MIDI data from a

computer.

Playing on the keyboard

produces an unnatural sound

when connected to a computer.

Cannot record chord

accompaniment data on a

computer.

The keyboard starts up

abnormally when it is turned

on.

1. The tuning or transpose

parameter is set to a value other

than 00.

2. Mixer coarse tune, fine tune, and/

or octave shift settings are values

other than 00.

The number of tones being played

at the same time exceeds the

keyboard’s limitation.

1. Channels are turned off.

2. Volume setting is too low.

1. One or more of the melody

channels (2 through 4) is turned

off.

2. The volume setting of one or more

of the melody channels (2 through

4) is too low.

3. The keyboard is in record

standby.

4. The SMF Player Mode is currently

being use.

1. USB cable is not connected

properly.

2. Channel is turned off, or volume

setting is too low.

The computer’s MIDI Thru function

is turned on.

Accomp/Song MIDI Out is turned

off.

1. Flash memory is corrupted. There

is something wrong with the card.

2. The keyboard detected abnormal

flash memory data and is

automatically resetting the

keyboard system.

1. Change the transpose or tuning

parameter value to 00.

2. Use the Mixer to change the

coarse tune, fine tune, and/or

octave shift settings to 00.

Use the Mixer to turn unneeded

channels off and decrease the

number of parts being played.

1. Use the Mixer to turn channels

on.

2. Use the Mixer to check the

volume setting.

1. Use the Mixer to turn on

Channels 2 through 4.

2. Use the Mixer to raise the volume

setting of Channels 2 through 4.

3. The LAYER and SPLIT buttons

are disabled during recording

and record standby.

4. Turn off the SMF Player Mode.

LAYER and SPLIT are not

available while the SMF Player

Mode is in use.

1. Connect USB cable properly.

2. Use the Mixer to turn the channel

on, or raise the volume setting.

Turn off the MIDI Thru function on

the computer or turn off Local

Control on the keyboard.

Turn on Accomp/Song MIDI Out.

1. a. Remove the batteries from the

keyboard and disconnect the

AC adaptor and press the

POWER button.

b. Reload the batteries and/or

reconnect the AC adaptor, and

then press the POWER button

again to turn on power.

c. Use the TRANSPOSE/

FUNCTION button to perform

the system reset operation.

•If this does not solve the

problem, contact your

nearest authorized CASIO

Service Provider to request

repair.

2. Wait (about 40 seconds) until the

“Pls Wait” message disappears

from the display.

E-69, 70

E-42

E-40

E-41

E-40

E-41

E-66, 67

E-75

E-81

E-40, 41

E-74

E-14, 15

E-74

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Casio WK-3800 Seite 100

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Casio WK-3800

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info