585929
14
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
EN-12
Power Requirements
Remove the battery compartment cover located in
the center of TRACKFORMER’s bottom panel, and
load six AA-size batteries into the battery
compartment. Make sure the plus and minus ends of
the batteries are facing as shown in the illustration.
Low Battery Indication
The following shows the amount of operating time that
can be expected under battery power.
Approximately 4 hours
Using a high volume setting, low ambient
temperature, and certain performance styles can
shorten battery life.
IMPORTANT!
General guidelines concerning battery life are
provided above. Note that actual battery life depends
on the type of battery being used.
Replace batteries at least once a year. In particular,
leaving dead rechargeable (eneloop, EVOLTA)
batteries loaded in the product creates the risk of
deterioration of the rechargeable batteries. Remove
batteries from TRACKFORMER as soon as possible
after they go dead.
Be sure to turn off TRACKFORMER before replacing
batteries.
When replacing batteries, be sure to load a full set of
six new AA-size batteries, or a set of fully charged
AA-size rechargeable batteries (eneloop or
EVOLTA). Using batteries other than those specified
or mixing old and new batteries can greatly shorten
battery life and result in malfunction.
Low battery power is
indicated when the 12
buttons of the EFFECT/
AUTO LOOP area flash.
Replace batteries with new
ones as soon as possible.
While TRACKFORMER is connected to a computer
with a USB cable, it can be operated on the power
supplied over the cable.
IMPORTANT!
Incorrect connections can make normal operation
impossible. Connect TRACKFORMER to a computer
as described by the procedure below.
Once you are able to connect successfully, you can
leave the USB cable connected when you turn off
your computer and/or TRACKFORMER.
Use a USB 2.0 cable.
TRACKFORMER does not charge rechargeable
batteries. (Use the specified charger for charging.)
1.
Turn off TRACKFORMER and then start up
your computer.
Do not start up your computer’s music software yet!
2.
Use a commercially available high-speed
USB 2.0 cable to connect TRACKFORMER
to your computer.
3.
Turn on TRACKFORMER.
For information about how to connect with a computer,
see the separate Tutorial Manual.
4.
Start up music software on your computer.
IMPORTANT!
Be sure to turn on TRACKFORMER before starting
up your computer’s music software.
Using USB Bus Power
USB cable
(A-B type)
USB
A connector
Computer USB port
TRACKFORMER USB port
B connector
XWDJ1-ES-1A.indd 14 2014/11/28 17:15:49
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Casio XW-DJ1 -DJ CONTROLLER wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Casio XW-DJ1 -DJ CONTROLLER

Casio XW-DJ1 -DJ CONTROLLER Bedienungsanleitung - Deutsch - 23 seiten

Casio XW-DJ1 -DJ CONTROLLER Bedienungsanleitung - Holländisch - 23 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info