Bedienungsanleitung Caso AF200 - 3172 (Seite 30 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

634816

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

caso AF200 30

12.3 Setup location requirements

In order to ensure the safe and trouble-free operation of the device, the setup location

must fulfil the following prerequisites:

• The device must be set up on a firm, flat, horizontal and heat resistant surface with

sufficient load-bearing capacity for the device.

• Choose the setup location in such a way that children cannot reach the device.

• The device is not intended to be installed in a wall or a built-in cupboard.

• Do not set up the device in a hot, wet or extremely damp environment or near

flammable material.

• The device requires an adequate flow of air in order to operate correctly. Leave a

clearance of 15 cm on all sides.

• Do not cover up any openings on the device and do not block these off.

• Do not remove the device’s adjustable feet.

• The electrical socket must be easily accessible so that the power lead can be

disconnected easily, in the case of an emergency.

• The installation and assembly of this device in non-stationary setup locations (e.g. on

ships) must be carried out by specialist companies / electricians, provided they

guarantee the prerequisites for the safe use of this device.

12.4 Unpacking

To unpack the device, proceed as follows:

• Place the box containing the unit on a countertop or table.

• Remove the device from the box and remove the outer packaging.

• Remove all the stickers or labels (except for the rating plate!).

Disposal of the packaging

The packaging protects the device against damages during transit. The packaging

materials are selected in accordance with environmentally compatible and recycling-

related points of view and can therefore be recycled.

Returning the packaging back to the material loop saves raw materials and reduces the

quantities of accumulated waste. Take any packaging materials that are no longer required

to “Green Dot” recycling collection points for disposal.

Please note

► If possible, keep the original packaging for the device for the duration of the guarantee

period of the device, in order that the device can be re-packaged properly in the event

of a guarantee claim.

12.5 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following

instructions must be observed for the electrical connection:

• Before connecting the device, compare the connection data (voltage and frequency) on

the rating plate with those of your electrical network. This data must agree in order that

no damages occur in the device. If in doubt, ask your qualified electrician.

• The electrical outlet must be protected by a 16A safety cut-out switch.

Do not use an extension lead. If you accept liability for doing so, only use an extension

lead which is in good condition and is suited to the power of the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Caso AF200 - 3172 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info