11
D
E
CO
R
A
T
IVE E
X
TRAC
T
OR H
O
O
D
Dear Customer
Thank you for buying our hood. Please read these instructions carefully for its
optimum installation, use and maintenance.
Notes: The gures mentioned in this manual are in the rst pages.
Hood installation the gures)
Warning: consult local regulations regarding fumes outlets. Do not
connect hood a fume, hot air Conrm that
room ventilation is appropriate with the local authorities. Make sure
the maximum air extraction ow rate for the appliances in the room does
not
extractor hood is
fuels. The evacuated air must be extracted through ducts that are used for
evacuating
regarding air extraction must be complied with.
Use a rigid PVC pipe with a min. Ø l20 mm to evacuate fumes outside.
The above restrictions do not apply to hoods with no fumes outlet to outside
(recirculation system with activated charcoal lter).
Install the hood in line with the instructions on the template Install the
hood in line with the instructions on the template provided.
For
at least 65 cm.
Connecting the hood to the grid
Warning: switch
and check that
indicated on the appliance nameplate.
If the extractor hood has a plug, connect it to a power socket in line with
applicable regulations, located in an accessible area.
If the hood does not have a plug, connect it directly to the electrical grid,
protected by a separator device accessible for disconnection, in line with local
regulations.
Use of the hood – Safety
Warning:
(e. g. lightning). This involves no risk of damage. Switch off the electricity
supply to the hood and reconnect after one minute.
Do
sensory mental) capabilities or lack of experience knowledge, unless
they have been
responsible for their safety.
Children should be supervised so that they do not play with the appliance.
To avoid the risk of re, clean the metal lter regularly, permanently control
pans containing hot oil and do not ambé food underneath the hood.
Do
ofcial distributor or authorised dealer.
Accessible parts may heat up when using cooking appliances.
Use of the hood - Control symbol in the gures)
The different control panels are described below. Check the panel model
installed on your hood and see the gure indicated in each case.
Panel with sliding switch (Fig. P1 )
1- Extractor fan speed - positions: OFF
2- Extractor fan operating control pilot light.
3- Lighting on and off switch.
Panel with electronic button (Fig. P2 )
1- Lighting on and off.
2- Lighting operating control pilot light.
3- Extractor
to switch off the extractor fan.
4- Extractor fan operating speed control pilot light.
Timer:
display
off. To cancel the timer: press the chosen speed button once.
Four-speed panel - Digital display (Fig. P3 )
1- Lighting on and off.
2- Extractor fan on and off.
3- Decrease extractor fan speed.
4- Extractor fan speed display panel.
5- Increase extractor fan speed.
6- Enable extractor fan turbo speed.
7- Enable and disable extractor fan timer
Timer: the
at each of the lower speeds until it stops and the lighting switches off.
Five-button panel (Fig. P4)
1- Extractor fan operating control pilot light.
2- Lighting on and off.
3- Extractor fan off.
4- Extractor fan speed - button: speed 1, 2 and 3
Touch panel (Fig. P5 )
1- Filter clean war display/button. Warning of the need to replace the
lter – press to deactivate once the lter has been cleaned or replaced.
2- Enable and disable extractor fan timer
3- Lighting on and off. Keep pressed down to adjust the lighting intensity.
4- Extractor fan on and off.
5- Extractor fan speed - button: speed 1, 2 and 3/4
Timer: extractor works 5 min. the speed 5
min. at each of the lower speeds until it stops.
Sliding touch panel (Fig. P6 )
1- Extractor fan on and off.
2- Sliding
with button -3-.
3- Lighting on and off. Press the button and, while it is ashing, adjust the
lighting intensity using the sliding touch panel -2- .
4- Enable and disable extractor fan timer
5- Filter clean war Warning of the need to replace the
lter – press to deactivate once the lter has been cleaned or replaced.
Timer: the
at each of the lower speeds until it stops and the lighting switches off.
Warning on the ZEN Model
The front panel automatically extends and retracts on switching the hood on/
off.
Hood maintenance
Warning: always switch off the electricity supply before carrying out
maintenance work on hood. In the event of fault, contact
ofcial distributor or authorised dealer.
Exterior cleaning: use non-corrosive, liquid detergent and avoid the use of
abrasive cleaning products.
Grease
display
hot
prevent solid remains from depositing on them.
Activated charcoal lters: replace the every 3 months.
Important: increase
is
manufacturer.
Bulb replacement symbol in the gures)
Warning: handle bulbs the supply been
switched off and they have cooled.
Important: use new bulbs according to that indicated on the hood
nameplate.
Use bulbs with an aluminium reector to replace halogen bulbs. Do not use
dichroic bulbs - risk of overheating.
On cooker
during operation of the motor. They should not be left on permanently and
used as a light source.
Legal information
The manufacturer:
- Declares
electrical equipment established in
and electro-magnetic compatibility
December 2004.
- Is
and current safety regulations for the correct use of the equipment.
- R
without prior notice.
Contact our ofcial distributor should you require technical assistance or
additional information on our products.
EN
