MAINTENA NCE
-Cleaning
Before any type of operation, always make sure that the electrical cord is disconnected and the switch is in the off position.
Clean the external part with a mild, liquid detergent and avoid the use of abrasive cleaning products.
-Changing the light
Before changing the light make sure that the hood is not connected.
Remove the grease filter and replace the light with a light bulb no more powerful than that specified in the Technical
Characteristics. Place the filter in position.
-Cleaning the grease filter.
Depending on use, and at least once a month the grease filters should be disassembled and cleaned in a dishwasher or with
hot soapy water.
If washed in a dishwasher, the filters should be placed in an upright position to prevent food remains from falling on them.
After rinsing and drying, replace the filters by following the steps for disassembly in rev erse order.
The active carbon filters must be replaced periodically to work properly, at least once every three months (depending on the
frequency with which the hood is used).
IMPORTANT WA RNING FOR EXTRACTOR HOODS WITH HA LOGEN LA MPS
If the halogen lamps need replacing, they must be replaced by lamps with an aluminium reflector, never dichroic lamps, to
avoid unnecessary overheating in the lamp holders.
• IMPORTANT:
• Do not connect the hood to chimneys, ventilation pipes or hot air pipes. Before connecting any pipes, consul
municipal ordinances on exhaust air and request permission from the person in charge of the building. Be sure
there is adequate ventilation, even in cases where the hood is to be used simultaneously w ith another product.
• Never leave frying food unattended since grease can overheat and catch fire. The risk of fire is even greater in
the case of used oil.
• Never use the hood in areas where devices with exhaust pipes connected to the outside are already operating
unless perfect ventilation can be guaranteed.
• To avoid the possibility of fire, adhere strictly to all of the recommendations included here and to the periodic
cleaning of the grease filters.
• During an electrostatic discharge (ESD) it is possible that the device will stop working. By switching the device
OFF an ON the device will again work as intended. There is no risk and no risk will appear.
• During climatic conditions causing electrical interference, it is possible that the device may stop working. B
switching the device OFF an ON the device will resume normal operation safety .
• If the supply cord of this equipment is damaged, it must only be replaced by manufacturer or it’s service agent o
similarly qualified person in order to avoid a hazard.
• Never have a lighted flame under the extractor hood.
• The appliance must be placed in such a way, that the supply plug is accessible.
• The hood must be installed at a minimum distance of 65cm from the stovetop.
.
.
THE MANUFACTURER WAIVES ALL LIABILITY FOR FAILURE TO OBSERVE THE INSTRUCTIONS FOR THE
APPROPRIATE INSTALLATION, MAINTENANCE AND USE OF THE EXTRACTOR HOOD.
The manufacturer declares that this product meets all the essential requirements for low voltage electrical material
set out in European directive 2006/95/EEC of 12 December 2006 and for electromagnetic compatibility as
required by European directive 2004/108/EEC of 15 December 2004.
If you need any technical help or would like more information about our products, please do not hesitate to contact
our official distributor.
THE MANUF ACTURER reserves the right to ef fect any technological improvement or modification without
prior notice.