Bedienungsanleitung Cateye HL-EL461RC - Volt400 (Seite 1 von 2) (Englisch)

602492

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

RECHARGEABLE HEADLIGHT

HL-EL461RC

Manual

1. Connect the light unit to your PC or

a commercial USB battery charger

using the USB cable. (

–

)

The switch or the indicator on the

cradle lights up, and charging starts.

Indicator light: On Charging

Indicator light: Off

Charging is completed

* When your PC is in sleep state, the

unit cannot be charged.

* We recommend using 500+mA

(USB2.0) USB battery charger.

2. After charging is completed, remove

the USB cable, and install the charge

jack cover.

* Charging and lighting times are ap-

proximate values, and will vary by en-

vironmental and user conditions.

* The cartridge battery can be fast-

charged by using the optional charging

cradle (about 3 hours of charging time).

Use a 1A or higher USB charging

adapter when charging by the cradle.

Before using the light, please read this manual

and the included separate sheet “LITHIUM-ION /

LITHIUM-ION POLYMER BATTERIES” thoroughly, and

keep them for future reference.

Rubber pad

Bracket

HOW TO CHARGE

CAUTION!

• Before your trip, please make sure the light is ﬁ rmly mounted to the

bracket, it lights up, and the light is not blocked by baggage, etc.

• Do not place it within children’s reach.

• In preparation for unexpected battery shutoff, we recommend you

carry a spare cartridge battery and light.

• Mounting the light unit too close to a wireless computer may

adversely affect the reading of the computer.

• This product is water-resistant under normal daily use and can

be used in the rain. However, do not intentionally submerge it in

water.

• If the light unit or parts become dirty with mud, etc., clean with a

soft cloth which is moistened with mild soap.

Never apply paint thinner, benzine or alcohol; damage will result.

• Dispose of used cartridge batteries appropriately according to

local regulations.

Before Initial Use

This unit is shipped with a small charge to check the light.

Be sure to charge it before use, according to the instructions

“HOW TO CHARGE”.

1. Mount the bracket to the handlebar.

(

–

)

2. Insert the light unit into the bracket

until it clicks, and adjust the beam

angle. (

)

3. To remove the light unit, pull out it

forward while pressing down on the

release button (

* To re-adjust the beam angle, loosen

the dial enough to move the bracket,

and ﬁ rmly tighten it after adjustment.

* The light can be mounted under the

handlebar.

CAUTION!:

• Be sure to tighten the dial by hand.

When you tighten it too hard with

a tool, the screw thread may be

stripped.

• Check the dial and screw (*1) on the

bracket periodically, and use them

without any loosening.

• Round off the cut edge of the bracket

strap to prevent injury.

HOW TO MOUNT

Standard

charging time

Approx.

6 h

(USB 2.0)

Strap

Dial

Release

button

Screw

Cradle

USB cable

Charge jack

cover

To PC or USB

battery charger

Charging on the cradle

Cartridge

battery

Indicator

Design Pat. Pending

EL461RC-150302 1

Cartridge battery

(BA-2.2)

FlexTight™ bracket

(H-34N)

USB cable

(MICRO USB)

Light unit

ENG

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cateye HL-EL461RC - Volt400 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info