Bedienungsanleitung Cateye MSC-CY300 (Seite 62 von 83) (Englisch)

473082

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

ENG-61

Continue

Altitude measurement function

This unit measures the atmospheric pressure using a built-in pressure sensor and

determines the altitude. It estimates the altitude using the relation between the altitude

and pressure of ISO 2533 (Standard atmosphere), which was developed based on the

international standard atmosphere speciﬁed by the International Civil Aviation Orga-

nization (ICAO). Generally, a conventional pressure sensor is affected by temperature

and can cause a large margin of error, but this unit is temperature-compensated and

records 1 meter resolution. This unit is designed not to reﬂect the change in atmo-

spheric pressure to the altitude measurement except during a ride; therefore, the alti-

tude is less prone to weather changes, so while not in motion, value shift is minimal.

The altitude measurement may change temporarily when going outside from an indoor *

room. This is due to a rapid temperature change, and is not a malfunction. It will return

to the normal value after a while.

Sea level altitude correction

There are 2 ways to correct the sea level altitude with this unit. It is recommended to

correct the sea level altitude just before measurement, taking either following methods.

The sea level altitude correction screen is displayed in Setup mode in the * MENU, or is

shortcut to from the orthrometric height screen in Clock mode or in Sports mode.

• REF (sea level altitude correction): Enter the altitude at the current point.

Enter the actual value at the point where the sea level altitude is

well known, such as along the seashore, or at a sign on the moun-

tain, etc.

Press and hold * MODE1 and SSS, or MODE2 and SSS, simultaneously

on the setting screen to reset the corrected value to the default value (a

value according to ISO2533).

• HOME (home altitude setting): Apply the altitude set beforehand.

Preset the sea level altitude at your home in advance. Move to the ALT

HOME screen, and then return to Clock mode or Sports mode by

pressing MENU or the relevant shortcut. Then, the sea level altitude

changes to the preset value. You can start with the correct sea level

altitude by setting home altitude before starting from your home.

Timing for updating the sea level altitude, ascending

altitude, and temperature

The timing for updating the sea level altitude, ascending altitude, and temperature

data differs depending on whether the Sports mode is in measurement or is

stopped.

Condition Timing for updating

When the Sports mode is in measurement, and a speed sensor signal is received

5 seconds

When the Sports mode is stopped, or no speed sensor signal is received

5 minutes

This is also valid in Clock mode.*

Basic knowledge of the altitude measurement

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cateye MSC-CY300 Seite 62

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cateye MSC-CY300

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info