Bedienungsanleitung Celestron 44127 Cosmos (Seite 2 von 20) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

791761

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

2 | ENGLISH

SPECIFICATIONS — MODEL # 44127

Stage Plain Stage with metal clips — 74 mm x 70 mm (2.9” x 2.8”)

Zoom Eyepiece Glass optics. Power continuous from 10x to 20x

Focuser Coarse focus — dual knobs

Objectives All glass optics — see magniﬁcation chart for powers

Illuminator — Top Pen light style

Illuminator — Bottom Uses 2AA batteries (user supplied)

Nosepiece Triple with click stop

Weight/Dimensions (with batteries) 17 oz. (482 g) — 5.25” x 3.13” x 9.75” (133 mm x 79 mm x 248 mm)

Objective Lens 4x 15x 30x

10x on Zoom Eyepiece 40x 150x 300x

20x on Zoom Eyepiece 80x 300x 600x

MAGNIFICATION TABLE

Use the following table to determine the magniﬁcation

for the different eyepiece/objective lens combination of your

microscope.

1. Take the Styrofoam container out of the carton.

2. Remove the tape from the Styrofoam container holding the

various parts in place.

3. Carefully remove the microscope and other parts from the

container and set them on a table, desk, or other

ﬂat surface.

4. Remove the plastic bag covering the microscope.

5. Remove the plastic cap from the zoom eyepiece

Fig. 1 (1).

6. Install the batteries for the bottom illuminator in the base

Fig. 1 (11) of the microscope which uses two AA batteries

(user supplied). See Figure 3a, showing the battery

compartment closed at the back of the microscope. Figure

3b shows the batteries being installed in the compartment

(see the inside of the battery compartment door to locate

where the positive (+) and negative (-) ends of the batteries

go). Pull out on the door to open it while holding the base

ﬁrmly and push ﬁrmly to close it after the batteries are

installed.

You are now ready to use your microscope for looking at

specimen slides or small objects through the zoom eyepiece!

SETTING UP YOUR MICROSCOPE

VIEWING A SPECIMEN

Carefully place a specimen slide under the stage clips Fig.

1 (8) and center the specimen directly over the hole in the

center of the stage Fig. 1 (7). Figure 4a shows the stage area

with the hole in the center and Figure 4b shows a specimen

slide centered over the hole in the stage. It will take some

experimenting to place slides or objects in the center of the

stage as the image you see is upside down and reversed

but after some usage you will have an easy time centering.

Read the sections below on Focusing, Changing Power, and

Illumination before proceeding.

You are now ready to focus and view the specimen, but ﬁrst

you must take some precautions so you do not damage a

specimen slide or valuable object. When using the higher

powers while you are focusing, make sure that the objective

lens does not hit the slide or object being viewed.

MICROSCOPE OPERATION

Figure 3a Figure 3b

Figure 4aFigure 4bFigure 5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Celestron 44127 Cosmos Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info