Bedienungsanleitung Celestron CGE Pro 1100 (Seite 29 von 72) (Englisch)

667041

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

adjust the slew limit on the side of the mount that is restricted by the cables, and command the mount the stop slewing before

it reaches this point. Or if you are taking an image of an object that has just crossed the Meridian, you can set the limit to allow

the mount to continue tracking in the same direction past the Meridian without the need to "flip" the telescope around to the

opposite side of the mount (see

Meridian feature above). Using the first example above, the user could slew the telescope in

R.A. (azimuth) until it reaches the point that the cables are extended to their maximum. Then by displaying the telescopes

azimuth in this position (by looking at

Get Axis Position under the Utilities menu) you can determine the telescopes azimuth at

its most extended position. Enter this azimuth reading for either the maximum or minimum azimuth slew limit to ensure that

the telescope will not slew beyond this point.

The telescope slew limits can be set to automatically stop anywhere between 40º above level to 20º below level (see figure 3-

4). To set the RA Slew limit select the following:

 RA East Limit- Enter a number between +40º to -20º to define the slew limit when the tube is on the east side of

the mount.

 RA West Limit - Enter a number between +40º to -20º to define the slew limit when the tube is on the west side

of the mount.

 Disable Limits – This disables any pre-defined values that have been entered and allows the mount to track the

maximum amount pass the Meridian (ie. -20º on both sides)

Warning: In order for the telescope to be able to slew to a star from the direction that minimizes the amount of backlash in the

gears, it may be necessary for the telescope to slew beyond the specified slew limit in order to approach the star from the

correct direction. This can limit your ability to slew to an object by as much as 6º from the RA slew limit set in the hand

control. If this proves to be a problem, the direction that the telescope takes to center an object can be changed. To change

the telescopes slewing direction, see

Goto Approach under the Scope Setup menu.

Utility Features

Scrolling through the MENU (9) options will also provide access to several advanced utility functions within the telescope

such as; Calibrate Mount, Hibernate as well as many others.

Calibrate Mount - In order to optimize the performance and pointing accuracy of the telescope, the mount has built-in

calibration routines allowing it to compensate for mechanical variation inherent in every German equatorial mount. Each

calibration is completely automatic and in most cases only needs to be performed once. It is highly recommended that you

take a few minutes to go through the mount calibration procedures.

Figure 3-4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Celestron CGE Pro 1100 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info