EN - Remote control & 3 Modules
(54755, 54756, 54760, 54797)
Install the receiver.
1° Cut the power o.
2° Connect the AC 220V cabels to the IN terminals and the light cables to the
OUT terminals.
3° Turn the power on, the led light blinks.
4° Link module and remote control (cf. Link code)
Link Code :
1° Bring the transmitter near the receiver, push the socket learning button once.
2° Receiver led will blink slowly, push the remote control ON button.
3° Receiver connected lamp will blink twice, code is confirmed and led stops
blinking.
Install the transmitter :
See drawings.
- On/O : Push On (O) button tu turn on (o) the light or device.
- Dimmer : Push On button twice, light begins to dim. Push once again, light
stops at chosen intensity. To dim again, restart the process.
* WORKS ONLY WITH DIMMER RECEIVERS.
Delete a code :
1° Push the learning button on receiver once, led blinks slowly.
3° Push the transmitter OFF button of the remote control.
4° Receiver connected lamp will blink twice, code is deleted and led stops
blinking. Repeat Link steps for re-setting.
Delete all memories :
1° Push the learning button on receiver for 6 seconds, led blinks.
2° Release and push again once.
3° Receiver connected lamp will blink twice, memory is erased and led stops
blinking.
* ALL PROGRAMMED MEMORY WILL BE DELETED.
Receiver has 6 memory settings :
Self program function receiver has 6 memory settings. It can be programmed as
to your requirement with special eect. It can be programmed to switch ON at
one time individually or programmed with dierent combinations switching.
This means one receiver can be programmed into max. 6 dierent combination.
Example : if there is 3 receivers (1. lamp shade, 2. night light, 3. fan). Receiver 1,2,3
can be control individually with transmitter button 1,2,3. Receiver 1,3 can be
programmed with transmitter button 4, (lamp shade and fan ON/OFF at same
time). Receiver 1,2,3 can also be programmed into group function ALL ON or OFF
at same time into group button (lamp shade, night light and fan ON/OFF at same
time)
Fault finding:
No activation : Check battery polarity or running out battery. Check code
program sucessful.
Caution:
Do not place two receivers near each other, the distance should be above 1
meter. Transmission distance is about 30m, but it can be reduced depending on
wall thickness or wireless environment.
Warning!
Do not use in samp places.
www.di-oCFt%FDMBraUJPOT$&t
Hereby DIO declares that the device is in conformity with the essential requirements and the
other relevant disposals of the directive 1999/5/CE.
IMPORTANT (DirectivF&$ WEEE) :
During the sorting of your waste, we ask you to respect the
regulations in eect regarding their elimination.
We thank you for depositing them in a place allowed to
this purpose and respecting the environment.
