555436
39
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
38
Diagnostic Chart
Your garage door opener is programmed with self-diagnostic capabilities. The UP and DOWNarrowson the garage door opener flash the diagnostic codes.
DIAGNOSTIC CODE SYMPTOM SOLUTION
Up Arrow
Flash(es)
Down Arrow
Flash(es)
1 1
The garage door opener will not close and the light bulbs flash. Safety sensorsare notinstalled,connected, or wires may be cut. Inspect sensor wires for a
disconnected or cut wire.
1 2
The garage door opener will not close and the light bulbs flash. There is a short or reversed wire for the safetysensors. Inspectsafetysensor wire at all staple and
connection points, replace wire or correct as needed.
1 3
The door control will notfunction. The wires for the door control are shorted or the door control isfaulty. Inspect door control wires at all
staple and connection points, replace wire or correct as needed.
1 4
The garage door opener will not close and the light bulbs flash. Safety sensorsare misaligned or were momentarily obstructed.Realign both sensors to ensure both
LEDs are steadyand not flickering. Make sure nothing is hanging or mounted on the door that would
interruptthe sensor’s path while closing.
1 5
Door moves6-8" stops or reverses. Manuallyopen and close the door. Checkfor binding or obstructions,such as a broken spring or door
lock, correctas needed. Check wiring connections at travel module and at the logic board.Replace
travel module if necessary.
No movement, only a single click. Manually open and close the door. Check for binding or obstructions,such as a broken spring or door
lock, correctas needed. Replace logic board if necessary.
Opener hums for 1-2 seconds no movement. Manually open and close the door. Check for binding or obstructions,such as a broken spring or door
lock, correctas needed. Replace motor if necessary.
1 6
Door coastsafter it has come to a complete stop. Program travel to coasting position or have door balanced bya trained door systemstechnician.
2 1-5
No movement, or sound. Replace logicboard.
3 2
Unable to setthe travel or retain position. Check travel module for proper assembly,replace if necessary.
Troubleshooting
39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Chamberlain WD832KEV wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info