Bedienungsanleitung Charnwood Arc 7 (Seite 6 von 24) (Englisch)

694418

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

RIDDLING

When burning wood, ash should be allowed to build up and only

riddled when the ash begins to cover the rear fireplate. The fire

should be riddled with the door shut (see Fig.2). Place the operating

tool onto the riddling lever and rotate between the open and closed

positions several times. Too much riddling can result in emptying

unburnt fuel into the ashpan and should therefore be avoided. After

riddling, the grate should be put back into the closed position for

burning wood.

On initial lighting, the stove may smoke and give off an odour as the

silicon paint with which the firebox is painted reacts to the heat. This

is normal and will cease after a short time, but meanwhile the room

should be kept well ventilated.

At first only light a small fire and burn it slowly for two hours to allow

any residual moisture in the chimney to evaporate.

Light the stove using dry kindling wood and paper or fire lighters. Put

the paper, or fire lighters, and kindling in the firebox and cover with a

few small dry logs. Open the air control fully (see Fig. 3). Light the

paper or fire lighters. The door may be left cracked open for a few

minutes to assist the combustion and heat up the firebox more

LIGHTING

quickly. When the kindling wood is well alight add a few more small

logs, close the door but leave the air control fully open. When the

flames are established around these logs, load the stove with the

required fuel load. Maintain the air control at maximum at this stage.

Once the fire is up to temperature the airwash system will begin to

work, so allow the fire to become hot before adjusting the air control

to the required setting. During the lighting period, do not leave the

stove unattended. Do not leave the door open except as directed

above to avoid excessive smoke.

When relighting the stove, leave the ash on the base if burning wood,

unless it is becoming too deep, in which case some of it may be

removed.

When the fire is burning normally the air control gives enough

airwash to keep the glass clean. However, it will not always be

possible to keep the glass clean with the air control fully closed. For

correct firing we recommend the use of a stove pipe thermometer

which may be purchased from your supplier or from Charnwood.

CONTROLLING THE FIRE

The rate of burning and hence the output is controlled by the air

control (see Fig.3).

Open the air control fully (boost position) when lighting or when

rapid burning is required. It should not be left fully open for long

periods as this can cause over-firing or excessive smoke production.

For high output move the air control to the ‘click position’ or for low

burning to the fully closed position.

The Charnwood Arc is fitted with an air control stop for use in a

smoke control area. This stops the stove from burning too slowly.

OPERATING INSTRUCTIONS

Air Control

Pull out to open

Push in to close

Door Handle

Pull to open Riddler Knob

Identification Plate,

Lift Plate to View

High

Output

Boost Low

Output

Fig. 3 Stove controls

Fig.2 Riddling tool Solid Fuel

Wood

Fig.1 Operating the multi grate

Pull lever out when burning solid fuel

Wood

Solid Fuel

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Arc 7 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Arc 7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info