Bedienungsanleitung Charnwood Cove 3 (Seite 5 von 20) (Englisch)

632313

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

to become hot before adjusting the air controls to the required

setting.

On initial lighting, the stove may smoke and give off an odour as the

silicon paint with which the firebox is painted reacts to the heat. This

is normal and will cease after a short time, but meanwhile the room

should be kept well ventilated.

At first only light a small fire and burn it slowly for two hours to allow

any residual moisture in the bricks to evaporate.

When relighting the stove, riddle slightly, and then empty the ashpan.

The fire is controlled by the single air control knob shown in Fig. 1.

Pull the knob out to make the fire burn faster, push it in to make the

fire burn slower.

When burning wood, ash should be allowed to build up and only

CONTROLLING THE FIRE

This unique QuattroFlowTM air control* provides carefully balanced

primary, secondary, tertiary and bypass air to enable optimum

burning conditions without the need to fiddle with multiple controls.

For correct firing we recommend the use of a stove pipe

thermometer which may be purchased from your supplier or from

ourselves.

RIDDLING

*Patent No.2389414

riddled when the ash begins to cover the slots in the rear fireplate.

The fire should be riddled with the door shut (see Fig. 2). Place the

tool onto the riddling lever and rotate between the 1 o'clock and 3

o'clock positions several times. Too much riddling can result in

emptying unburnt fuel into the ashpan and should therefore be

avoided. After riddling, the grate should be put back into the

position as required (the tool should be in the 1 o'clock position for

open grate or in the 5 o'clock position for closed grate).

Keep the firebox well filled but do not overfill to prevent fuel from

spilling over the top of the front fire bar. Logs should be evenly

distributed filling across the fire bed to give the most pleasing flame

pattern.

Care should be taken especially when burning wood that fuel does

not project over the front fire bar or damage to the glass may be

caused when the door is closed, it can also cause the glass to blacken.

The ashpan should be emptied regularly before it becomes too full.

Never allow the ash to accumulate in the ashpan so that it comes in

contact with the underside of the grate as this will seriously damage

REFUELLING

ASH CLEARANCE

Maximum filling height is such that logs cannot fall from the fire when

the doors are opened. Liquid fuels are not to be used on this stove.

Fig. 3. Ashpan Removal

Tongue must be visible to

ensure correct tool location.

Cove 2 & 3

Fig. 2. Multi Grate

Open Position

Closed Position

Riddle

Closed Position

Open Position

Cove 2 & 3

Riddle

Door Opening Tool rotated 180°

and pushed fully on to Riddler Knob

charnwood

OPERATING INSTRUCTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Cove 3 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Cove 3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info