Bedienungsanleitung Charnwood Haven (Seite 6 von 20) (Englisch)

815471

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

When relighting the stove, leave the ash on the base, unless it is

becoming too deep, in which case some of it may be removed by

riddling the grate to empty it into the ashpan.

CONTROLLING THE FIRE

The rate of burning and hence the output is controlled by the air

control (see Fig.1)

Open the air control fully (high position) when lighting or when rapid

burning is required. It should not be left fully open for long periods

as this can cause over-firing or excessive smoke production. For most

efficient output move the air control to the ‘nominal position’ or for

low burning to the low position.

When the fire is burning normally the air control gives enough

airwash to keep the glass clean. However, it will not always be

possible to keep the glass clean with the air control fully closed. For

correct firing we recommend the use of a stove pipe thermometer

which may be purchased from your supplier or from Charnwood.

The Charnwood Haven is fitted with an air control stop for use in a

smoke control area. This stops the stove from burning too slowly.

WOOD ASH REMOVAL GRATE

Your Charnwood Haven is fitted with a wood ash removal grate to

enable wood to be burned and ash to be cleared.

Movement of the grate from one position to the other is effected

using the operating tool supplied as shown in Fig.2.

The grate is put into the open position by turning the operation tool

anticlockwise. The grate is put into the closed position by turning

the operation tool clockwise. To riddle the appliance the tool should

be moved between the clockwise and anticlockwise positions several

times. When burning wood, the grate must be in the ‘open’ position

as shown in Fig.2.

RIDDLING

When burning wood, ash should be allowed to build up and only

riddled when the ash begins to cover the rear fireplate. The fire

should be riddled with the fire door shut (see Fig.2). Place the

operating tool into the riddling lever and rotate between the open

and closed positions several times. Too much riddling can result

in emptying unburnt fuel into the ashpan and should therefore be

avoided. After riddling, the grate should be put back into the open

position.

Fig. 2 Riddling

OPERATING INSTRUCTIONS

Nominal

click

High

Output Low

Output

AIR CONTROL

Oven handle

Pull to open

Riddling knob

Use the operating tool to

riddle. The stove should be

run with the grate in the

‘open’ position. (See fig. 2)

Operating

tool storage

Store the

operating tool

when not in

use

Oven

thermometer

Indicates

approximate oven

temperature

Serial label

Slide out to view,

scan QR code to

Cooking plate

The temperature of the cooking plate is graded, with the hottest point

located directly above fire for boiling.

Flue Diverter

Forward ( Position 1) -

Lighting

Back (Position 2) -

Normal operation

Fire Door Handle

Twist clockwise to

open

Fig. 1. Stove Controls

Open

Riddle

Closed

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Haven Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info