Bedienungsanleitung Charnwood Island 3B (Seite 5 von 16) (Englisch)

632324

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

just one control to be used. The balance between primary and

secondary air for particular flue conditions is pre-set using the sliding

control mounted on the thermostat box beneath the stove. Once set

this should not need to be adjusted.

When burning wood, ash should be allowed to build up and only

riddled when the ash begins to cover the slots in the rear fireplate.

The fire should be riddled with the doors shut (see Fig. 2). Place the

tool onto the riddling lever and rotate between the 1 o'clock and 3

o'clock positions several times. Too much riddling can result in

emptying unburnt fuel into the ashpan and should therefore be

avoided. After riddling, the grate should be put back into the open or

closed position as required (the tool should be in the 1 o'clock

position for open grate or in the 5 o'clock position for closed grate).

Keep the firebox well filled but do not overfill to prevent fuel from

spilling over the top of the front fire bar. Logs should be evenly

distributed, filling the firebed to give the most pleasing flame pattern.

Care should be taken, especially when burning wood, that fuel does

not project over the front fire bar or damage to the glass may be

caused when the doors are closed. It can also cause the glass to

blacken. Maximum filling height is such that logs cannot fall from the

fire when the doors are opened. Liquid fuels are not to be used on

this appliance.

The ashpan should be emptied regularly before it becomes too full.

Never allow the ash to accumulate in the ashpan so that it comes in

contact with the underside of the grate as this will seriously damage

the grate bars. The ashpan is handled using the tool provided. Care

should be taken to ensure that ash is cool before emptying it into

plastic liners or bins.

To make ash removal easier there is a special Charnwood ash carrier

available. This may be purchased from your supplier or, in case of

difficulty, from ourselves.

For correct firing we recommend the use of a stove pipe

thermometer which may be purchased from your supplier or from

ourselves.

RIDDLING

REFUELLING

ASH CLEARANCE

Open Position

Closed Position

Riddle

Fig. 2. Multifuel Grate

the fuel is well ignited then load with fuel. Once the fire is up to

temperature the airwash system will begin to work, so allow the fire

to become hot before adjusting the thermostat to the required

setting.

On initial lighting, the stove may smoke and give off an odour as the

silicon paint with which the firebox is painted reacts to the heat. This

is normal and will cease after a short time, but meanwhile the room

should be kept well ventilated.

At first only light a small fire and burn it slowly for two hours to allow

any residual moisture in the bricks to evaporate.

When relighting the stove, riddle slightly and then empty the ashpan.

The fire is controlled by the water temperature thermostat. The

water temperature is set by the control knob shown in Fig. 1. Turn

the knob clockwise to increase the water temperature or anti-

clockwise to decrease.

This thermostat controls both primary and secondary air, enabling

CONTROLLING THE FIRE

Fig. 3. Secondary air Adjustment

OPERATING INSTRUCTIONS

charnwood

I S L A N D

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Island 3B Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Island 3B

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info