Bedienungsanleitung Charnwood Island I (Seite 6 von 20) (Englisch)

632320

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

blacken. Maximum filling height is such that logs cannot fall from the

fire when the doors are opened. Liquid fuels are not to be used on

this appliance.

The ashpan should be emptied regularly before it becomes too full.

Never allow the ash to accumulate in the ashpan so that it comes in

contact with the underside of the grate as this will seriously damage

the grate bars. The ashpan is handled using the tool provided. Care

should be taken to ensure that ash is cool before emptying it into

plastic liners or bins.

To make ash removal easier there is a special Charnwood ash carrier

available. This may be purchased from your supplier or, in case of

difficulty, from ourselves.

The stove is finished with a high temperature paint which will

withstand the temperatures encountered in normal use. This may be

cleaned with a damp lint-free cloth when the stove is cold. Should re-

painting become necessary then special high temperature paints are

available from your supplier or from Charnwood.

The glass in the doors is a special ceramic glass which is able to

withstand high temperatures. Before cleaning the glass open the

doors and allow them to cool. Clean the glass using a damp cloth and

then wipe over with a dry cloth. Any stubborn deposits on the glass

may be removed with a proprietary stove glass cleaner or ceramic

hob cleaner. Some deposits on the glass may be burnt off simply by

running the fire at a fast rate for a few minutes. Do not use abrasive

cleaners or pads as these can scratch the surface which will weaken

the glass and cause premature failure. Aerosol spray cleaners should

not be used near the appliance whilst it is under fire.

If the fire is going to be out of use for a long period (for instance in

the summer) then to prevent condensation, and hence corrosion, the

air control should be left fully open and the fire doors left ajar. It is

also advisable to sweep the chimney and clean out the fire. Spraying

the inside of the doors and firebox with a light oil, such as WD40,

will also help to keep all internal parts working well.

After long periods where the fire has been out of use, the chimney

and appliance flueways should be cleaned before lighting.

ASH CLEARANCE

MAINTENANCE

Cleaning

Cleaning the Glass

When Not in Use

Door Seals

Servicing

For the fire to operate correctly it is important that the door seals

are in good condition. Check that they do not become worn or

frayed and replace them when necessary.

It is recommended that the fire is serviced once a year to keep it in

first class working order. After cleaning out the firebox thoroughly,

check that all internal parts are in good working order, replacing any

parts that are beginning to show signs of wear. Check that the doors

seals are in good condition and that the doors seal correctly. A

servicing guide is available on request. Repairs or modifications may

only be carried out by the Manufacturer or their approved agents.

Use only genuine Charnwood replacement parts.

It is important that the throat plate and all the stove flueways are kept

clean. They should be checked approximately once a week, by

looking up into the firebox for signs of soot or fly-ash on the throat

plate and at the sides of the firebox. If there are signs of a build up of

soot or fly-ash deposits then the fire must be let out in order to clean

the throat plate and flueways.

Before attempting to clean the throat plate and flueways, ensure that

the fire is cold. Wear suitable gloves to prevent irritation from soot

deposits. To remove the throat plate lift the front edge up and slide

the plate forward until it comes clear of the front pegs, then swing

the front edge down (see Fig. 3).

The chimney should be swept at least once a year. Where a top

outlet is used it will generally be possible to sweep the chimney

through the appliance.

First remove the side fire plates, and the throat plate.

Then sweep the chimney ensuring that soot is removed from all

horizontal surfaces after sweeping.

In situations where it is not possible to sweep through the appliance

the installer will have provided alternative means, such as a soot door.

After sweeping the chimney the appliance flue outlet and the flue

pipe connecting the stove to the chimney must be cleaned with a flue

brush.

After clearing any soot from within the stove, replace the throat plate

THROAT PLATE AND

FLUEWAY CLEANING

CHIMNEY SWEEPING

front firebar,

OPERATING INSTRUCTIONS

charnwood

I S L A N D

IIIII

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Island I Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Island I

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info