Bedienungsanleitung Charnwood LA45 (Seite 7 von 18) (Englisch)

815489

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

surfaces simply wipe over with a dry cloth. Abrasive pads and

scouring cleaners must not be used as these will damage the

finish. Care should be taken not to knock the enamel with

hard objects as it will chip.

Cleaning the Glass

The glass in the doors is a special ceramic glass which is able

to withstand high temperatures. Before cleaning the glass

open the doors and allow them to cool. Clean the glass using

a damp cloth and then wiping over with a dry cloth. Any

stubborn deposits on the glass may be removed with a

proprietary stove glass cleaner or ceramic hob cleaner. Some

deposits on the glass may be burnt off simply by running the

fire at a fast rate for a few minutes. Do not use abrasive

cleaners or pads as these can scratch the surface which will

weaken the glass and cause premature failure. Aerosol spray

cleaners should not be used near the appliance whilst it is

under fire.

When not in use

If the fire is going to be out of use for a long period, (for

instance in the summer,) then to prevent condensation, and

hence corrosion, the thermostat should be left at the

maximum setting and the main doors left ajar. It is also

advisable to sweep the chimney and clean out the fire.

Spraying the inside of the doors and firebox with a light oil,

such as WD40, will also help to keep all internal parts

working well.

After long periods where the fire has been out of use, the

chimney and appliance flueways should be cleaned before

lighting.

Door Seals

For the fire to operate correctly it is important that the door

seals are in good condition. Check that they do not become

worn or frayed and replace them when necessary.

Servicing

It is recommended that the fire is serviced once a year to

keep it in first class working order. After cleaning out the

firebox thoroughly, check that all internal parts are in good

working order, replacing any parts that are beginning to show

signs of wear. Check that the door seals are in good condition

until the fire is burning brightly before filling with fuel.

If the central heating pump is off overnight, the thermostat

may be left at the same setting for both day and night

operation. If the central heating pump is on overnight, then set

the thermostat control to give the required level of heating.

Some experimentation may be necessary to find the setting

most suitable for the particular fuel used and the draw on the

chimney. For overnight burning the fire doors must be closed.

To revive the fire, empty the ashpan if necessary, riddle, and

turn the thermostat control knob to maximum. When the fire

is burning well load on more fuel as necessary and, when

flames are well established above the fuel bed, turn the control

knob to the desired setting.

THROAT PLATE AND FLUEWAY CLEANING

It is important that the throat plate and all the appliance

flueways are kept clean. When burning smokeless fuels they

should be cleaned at least monthly and more frequently if it is

found necessary.

The throat plate and flueways may be cleaned with a low fire

still burning. Lower the throat plate using the throat plate tool.

To do this engage the end of the tool in the throat plate as

shown in Fig. 4, pull the plate forward and then lower it. Use

the scraper tool to push any sooty deposits up the plate until

they fall off the back and into the fire. While the throat plate is

in the lowered position also scrape any soot deposits from the

sides and top of the firebox. Ensure that soot deposits are not

allowed to build up on the side boiler faces: if the throat plate

becomes tight between the faces it could fail prematurely.

Return the throat plate to its correct position - raise the front

of the plate, push it back and then lower it onto the retaining

lugs. The upper set of lugs are for use when burning smokeless

fuels (see Fig. 4).

More soot will be deposited on the throat plate and in the

flueways if the appliance is run at low levels for long periods. If

this is the case then more frequent cleaning will be necessary.

MAINTENANCE

Cleaning

The appliance is finished in vitreous enamel. To clean the

OPERATING INSTRUCTIONS charnwood

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood LA45 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info