Bedienungsanleitung Charnwood Skye 5 (Seite 14 von 24) (Englisch)

694420

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Fig. 11. Flue Blanking Plate

PRE LIGHTING CHECK

Ensure that upper throat plate (Skye 7, top flue outlet connection

only) and the throat plate is fitted in the roof of the appliance. The

location and positioning of the throat plate is shown in Fig. 6.

Check that the front fence is fitted correctly and that the door closes

properly.

COMMISSIONING

On completion of the installation allow a suitable period of time for

the fire cement and mortar to dry out before lighting the fire. Make

a layer of ash or sand on the base of the stove before lighting. Check

to ensure that smoke and fumes are taken from the appliance up

the chimney and emitted safely. Also check all joints and seals. On

completion of the installation and commissioning please leave the

operating instructions with the customer and advise them on the use

of the appliance.

Flue draught can be checked by removing the bolt that is located

to the right of the rear flue exit behind the rear panel (Skye 5) or

removing the bolt underneath the front left hand side (Skye 7)

FITTING THE REAR HEAT SHIELD

The Skye is supplied with an optional rear heat shield. When fitted to

the back of the stove it will reduce the rear distance to combustibles:

Skye 5: 90mm Skye 7: 100mm

To fit the optional rear heat shield, loosen the button head allen

screws and slide the heat shield on so that the slots on the back of

the heat shield fit over the screws. (fig. 12)

Fig. 12. Fitting the optional rear heat shield.

CAA AND SMOKE CONTROL

The Clean Air Act 1993 and Smoke Control Areas

Under the Clean Air Act local authorities may declare the whole or

part of the district of the authority to be a smoke control area. It

is an offence to emit smoke from a chimney of a building, from a

furnace or from any fixed boiler if located in a designated smoke

control area. It is also an offence to acquire an “unauthorised fuel”

for use within a smoke control area unless it is used in an “exempt”

appliance (“exempted” from the controls which generally apply in

the smoke control area).

In England appliances are exempted by publication on a list by the

Secretary of State in accordance with changes made to sections 20

and 21 of the Clean Air Act 1993 by section 15 of the Deregulation

Act 2015. Similarly in Scotland appliances are exempted bypublication

on a list by Scottish Ministers under section 50 of the Regulatory

Reform (Scotland) Act 2014.

In Northern Ireland appliances are exempted by publication on

a list by the Department of Agriculture, Environment and Rural

Affairs under Section 16 of the Environmental Better regulation Act

(Northern Ireland) 2016.

In Wales appliances are exempted by regulations made by Welsh

Ministers.

Further information on the requirements of the Clean Air Act can be

found here: https://www.gov.uk/smoke-control-area-rules

Back of Stove

Blanking Plate

Glass Fibre Webbing

Blanking Plate

Seal Blanking Plate with

Glass Fibre Webbing

Clamping plate finishes flush

with the inside face of the

firebox top and bottom.

Inside of Stove

Clamping Plate

M8 Nut

Slots in position

Optional rear heatshield

INSTALLATION INSTRUCTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Charnwood Skye 5 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Charnwood Skye 5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info