Instruction Manual TRIKE AIR
GB
Age: 18 m+
Please read these instructions carefully before use and keep them for future reference.
WARNINGS
WARNING!
TO PREVENT SERIOUS INJURIES
• Before using the product, remove and dispose of any plastic bags and any other packaging elements and keep them out
of reach of children. Suffocation risks
• This toy must only be assembled by an adult.
• Keep all unassembled parts out of children’s reach.
• Before using the product make sure it is assembled correctly and there is no visible damage.
• Check it regularly for signs of wear and damage and make sure the screws and bolts are tightened correctly.
• Should any part be visibly damaged, do not use the toy and keep it out of children’s reach.
• Always use under constant supervision of an adult.
• Only use this toy on at surfaces without obstacles.
• Never use it on sloping surfaces, near motor vehicles, roads, swimming pools, hills, car and lorry entrances or any other
hazardous areas.
• Check that the child’s shoes are fastened properly.
• The construction features of this toy mean it is not suitable for use by children over 5 years of age, or those weighing
over 20Kg/44lbs
• Make sure this toy is only used by one child at a time.
• Never allow a child to climb into the item basket: it could break and/or cause the Trike to overturn.
• Do not overload the basket with weights of over 1kg/2lbs.
• Do not put pressure or lift the Trike up by the rear handle when the child is using it.
• Always pay attention when going up and down steps or pavements.
• Using this toy in very low temperatures can cause the plastic material to lose its elasticity and become fragile; should
this happen, do not allow the child to use it and store it away in a suitable environment.
INTRODUCTION
This Chicco AIR Trike is a versatile product which allows parents to either guide their child using the hook—on extractable
handle or leave them to cycle on their own.
This toy is suitable for children from 18 months to 5 years of age.
ASSEMBLY
Follow the instructions below and the diagrams at the beginning of the manual to assemble the product:
Diagram 1 (Frame)
- insert the initial part of the frame (Part C) inside the end section (Part B). Use the supplied ttings to securely lock the
components together – Screw A + 1 washer C on one side and Nut A+ washer A + 1 washer C on the other. Check that
the screws penetrate both the frame parts and block them in position by tightly fastening the nuts using the supplied
multi-purpose key to ensure they are securely fastened.
Diagram 2 (Handle bar)
- begin by inserting Part N and then insert Part M on top of Part E. Make sure all the parts are tted in the right direction.
Also check the direction in which the pedals rotate (see the arrow on the wheel guard) and the light frontal grooves on
the mud-guard (see the diagram).
- The wheel block + mud-guard must be mounted on the frame so that the end of the wheel protrudes from the upper
section; now attach the washer (Part L) and fastener (Part I) without over tightening it.
- Insert the plastic guard (Part H) inside the handlebar tube (Part A).
- Insert the handlebar (Part A) in the wheel block tube, making sure it slides in until it reaches the notches visible on the
tube which indicate the minimum safety level that must be reached (see the diagram).
- Now rmly tighten the screws on the fastener, making sure the handlebar and wheel are aligned correctly.
- Check the correct assembly and fastener on the handlebar a few times to guarantee maximum levels of safety.
USA
