Bedienungsanleitung Chiq CTM215S (Seite 5 von 10) (Englisch)

797332

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

INSTALLATION INSTRUCTIONS

Before Using the Refrigerator

 Remove the exterior and interior packing.

 Before connecting the refrigerator to a power source, let the unit stand upright for

approximately 4 hours to mitigate the possibility of a malfunction in the cooling system from

improper handling during transportation.

 Clean the interior surface with lukewarm water using a soft cloth. (Refer to the cleaning

instruction on page 5)

Installing the Refrigerator

 This appliance is designed to be free standing only, and should not be recessed or built-in.

 Place the refrigerator on a leveled/even floor surface that is strong enough to support the

weight of the refrigerator when it is fully loaded to prevent vibrations and allow water to properly

drain. The front feet can be adjusted to level the appliance properly.

 The leveling feet should only be used in forward and backward motions and never side to side.

 Allow at least 5cm of space between the back and sides of the refrigerator to allow

proper air ventilation. Adjust the two front feet to keep the refrigerator leveled or elevated.

 Situate the refrigerator away from direct sunlight and sources of direct heat (stove, heater,

radiator, etc.). Direct sunlight may also affect the acrylic coating and heat sources may cause

an increase electrical consumption. Ambient temperature below 50°F or above 85°F will hinder

the performance of this appliance.

 This unit is not designed for outside installation.

 Avoid situating the refrigerator in moist OR pest infestation areas.

 Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

authorized service center.

 After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down

for 2~3 hours before placing food in the refrigerator or freezer compartment.

 Do not place items on the top of this appliance.

ENERGY SAVING TIPS

 Allow hot foods to cool to room temperature before placing in the refrigerator. Overloading the

refrigerator forces the compressor to work harder. Foods that freeze too slowly may lose

quality, or spoil.

 Do not adjust the temperatures colder than necessary. Refer to page 4 for temperature

instructions.

 Be sure to wrap foods properly, and wipe containers dry before placing them in the refrigerator.

This cuts down on frost build-up inside the refrigerator.

 Organize and label food to reduce door openings and extended searches. Remove as many

items as needed at one time, and close the door as soon as possible.

 Refrain from leaving the door/s open for a long time to conserve energy.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Chiq CTM215S Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info