Bedienungsanleitung Christopeit EL 5 (Seite 27 von 68) (Deutsch, Englisch, Holländisch, Französisch)

793036

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

English

Cleaning, Checks and Storage of the Ergometer

bike:

1. Cleaning

Use only a less wet cloth for cleaning. Caution: Never use benzene,

thinner or other aggressive cleaning agents for surface cleaning as

this damage caused.

The device is only for private home use and for use suitable indoors.

Keep the unit clean and moisture from the device.

2. Storage

Plug out the power supply unit while intending the unit for more than

4 weeks not to use. Choose a dry storage in-house and put some

spray oil at front & rear foot tube connection point and hand grip

axle. Cover the bike to protect it from being discolor by any sunlight

and dirty through dust.

3. Checks

We recommend every 50 hours to review the screw connections for

tightness, which were prepared in the assembly. Every 100 operating

hours, you should put some spray oil at front & rear foot tube con-

nection point and hand grip axle.

Troubleshooting

If you cannot solve the problem with the following information,

please contact the authorized service center.

Problem Possible Cause Solution

Computer has

no value at Dis-

play if you press

any key.

No power

adapter is well

plugged or wall

power is without

power.

Check that the power adapter

is properly plugged in, possibly

with another electric device

check if the wall power is ﬁne.

Computer is

not counting

data and do not

switch on after

start cycling.

Sensor impulse

missing base on

not well plugged

connection

Check the plug connections at

computer and inside of handle-

bar support.

Computer is

not counting

data and do not

switch on after

start cycling.

Sensor impulse

missing base on

not correct posi-

tion of sensor.

Take off the cover and check

the distance between magnet

and Sensor. The magnet at

turning belt wheel should have

only less than < 5mm distance

against the sensor position.

No pulse value Pulse cable is

not plugged in.

Check the separately pulse

cable is well connected with

computer.

No pulse value Pulse sensors

not well connec-

ted

Screw out the screw for pulse

measurement and check if

plugs are well connected and no

damage at pulse cable.

Training area in mm

(for home trainer and user)

Free area in mm

(Training area and security area

(rotating 60cm))

Max Heart Rate in Program 18, and 95% Max Heart Rate in Program 19.

After pressing „START/STOP“ key to exercise, please also apply the heart

rate detector appropriately. In these programs, the computer will adjust the

level of loading according to the heart rate detected. For example, the level

of loading may increase while the heart rate detected is lower than TARGET

H.R. Also, the level of loading may decrease while the heart rate detected is

higher than TARGET H.R. As a result, the user’s heart rate will be adjusted to

close the TARGET H.R. in the range of TARGET H.R. –5 and TARGET H.R.

+5. With the input of age, the computer may suggest a target heart rate to

exercise. The suggested heart rate is 80% (220 – age).

So, if the heart rate detected equals to or greater than the TARGET H.R.,

the value of HEART RATE will keep ﬂashing. Please note that it is a warning

for users to slow down or to lower the level of loading.

In program 20, press „F“ key to select TIME, DISTANCE, CAL. and TARGET

H.R. Users may setup a target heart rate to exercise in a period of time or

a certain distance.

TEST-Pulse Recovery:

It is a function to check the condition of pulse recovery that is scaled from 1.0

to 6.0 while 1.0 means the best and 6.0 means the worst and the increment

is 0.1. In order to get rated correctly, users must test it right after the workout

ﬁnished by pressing „TEST“ key and then stop exercising. After the key is

pressed, please also apply the heart rate detector appropriately. The test

will last for 1 minute and the result will show in the display.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Christopeit EL 5 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info