Bedienungsanleitung Ciclo HAC 5 (Seite 4 von 38) (Englisch)

588931

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

To save energy, the HAC5 turns off automatically at night, meaning the display turns off at

12 p.m. and only lights up again after pressing any button.

All functions active at the time of shut-off keep going internally despite the display turned

down.

2. Operational Setup

2.1 Attaching the HAC5 to the wrist band and the handlebar bracket

To take the HAC5 out of the wrist band or the handlebar holder, turn it 90° to the left, then remove.

To insert into the wrist band or handlebar bracket, insert at a 90° angle to the left, then turn to right

until it engages.

2.2 Inserting the batteries

•

Inserting the battery into the HAC5:

The HAC5 is delivered with battery inserted. Just press any button to start.

(As the HAC5 uses a high tech display with Dot-Matrix, the battery consumption is – like in many other

high tech devices – more extensive than in our other CicloSport computers.

Therefore two extra batteries are added).

•

Inserting the battery into transmitter belt, speed- and cadence transmitter:

Open the battery cap with the aid of a coin (turn to left). Insert battery type CR2032 with the plus

pole facing up and close the cap again.

2.3 Setup / Initialization

Because of the new digital transmission technique, all transmitters have to be initialized prior to first

use. We therefore recommend that you first conduct all necessary initializations (and, if required,

enter all required data) before attaching the parts to the bike. In chapter 5 you will find a step-by-step

setup as well for the initializations as for setup of time and date.

2.4 Installing

•

Installing the handlebar bracket:

The handlebar mounting can also be installed on a stem. To do this the top section

of the handlebar mounting must be removed from the bottom section. To make

it easier to remove the top section carefully push the sides of the bottom section

upwards slightly.

Then turn both parts through 90° and assemble them again until the snap-on

mounting engages.

Remove the backing foil from the underside of the handlebar mounting, place the

handlebar mounting in the required position on the handlebar (or on the stem) and

press it down slightly. Secure it with the O ring or with the cable ties.

• Installing the speed transmitter:

Attach the speed transmitter at the fork or the rear construction with the aid of the cable ties (the

printed side of the transmitter with the marking must point to the spokes).

Mount the magnet to a spoke directly opposite the marking on the transmitter.

Do not over tighten the fixing screw on the magnet. Adjust transmitter in such a way that the

distance between transmitter and magnet does not exceed 3 millimetres.

• Installing the cadence transmitter:

Attach the cadence transmitter to a strut opposite the pedal crank with the aid of the cable ties

(the printed side of the transmitter with the marking must point to the crank).

Mount the magnet on the pedal crank directly opposite the transmitter with the help of the cable

tie, so that the magnet points exactly to the marking on the transmitter. Adjust transmitter in such

a way that the distance between transmitter and magnet does not exceed 3 millimetres.

Inserting the batteries

Setup / Initialization

Installing

Attaching the HAC5

to the wrist band and

the handlebar bracket

Attention!

Mark

handlebar

bracket

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ciclo HAC 5 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ciclo HAC 5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info